Fitting Instructions - Probuilder 26580 Bedienungsanleitung

FITTING INSTRUCTIONS

1. Hold the mask in hand with the nose-
piece up. If folded mask, then open the
folded mask with the nosepiece up and
hold the mask in hand, allow head-
bands to hang freely.
3. Pull the lower headband over the
head and position below ears. Pull the
top headband on the back of head
above ears for best fit.
5. To check fit, cup both hands over the mask and exhale vigorously. If air flows
around nose, tighten the nosepiece. If air leaks around the edge, reposition and
adjust the headband for better fit.
Retest the seal and repeat the procedure until the mask is sealed properly.
2. Position the mask under the chin
covering mouth and nose.
4. Press soft nosepiece to conform
snugly around the nose.
15
GB