Important Precautions Regarding The Peristaltic Pump; Additional Information - Avady Propilot Salt Gebrauchsanweisung

MESSAGE
DISPLAYED/FAULT
Production
DETECTED

4.7.4. Important precautions regarding the peristaltic pump

When one of the 2 messages below is displayed, the peristaltic pump is running.
or
I
In this case, do not remove the front panel of the electronics unit under any circumstances.
If case of doubt about the correct functioning of the peristaltic pump:
1) Switch off the electronics unit.
2) Remove the front panel of the electronics unit.
3) Remove the flexible tubing inside the peristaltic pump.
4) Carry out a manual vacuum injection.

4.8. Additional information

Menu
IMMEDIATE
AUTOMATIC ACTION
Stop of pH
stopped regulation
Yes No
-time timer countdown
CAUSE
Salt level less than
2.5 g/L (or 1.5 g/L
if Low Salt
equipment).
Insufficient
amount of water
in the filtration
circuit.
Meaning
Control board programme
Power card programme
Configuration code
Serial number
MAC address for Bluetooth connection
Temperature inside the electronics unit
VERIFICATIONS AND
SOLUTIONS
Check the salt levels in the
pool using a recent testing
kit.
Top up with salt
necessary, so as to obtain
a salt level of 5 kg/m 3
2.5 kg/m 3 for Low Salt
equipment).
Check that the tubing on
the salt sensor
completely filled with
water.
If necessary, top up the
water in the pool.
OPTION TO
DEACTIVATE
VIA THE
MENU
if
(or
Yes
is
18