SuperFish Smart Fish Keeping LED Controller Benutzerhandbuch Seite 2

GB
Operation
The timer has standard been programmed to start the
light at 7:00 and switch off at 21:00.
You can change the settings to your own requirement.
By default (F1 setting) the light starts in Sunrise mode,
gradually start in 30 sec and stop in Sunset mode,
gradually stop in 30 sec.
You have the possibility to change this Default mode,
push 3 sec the « MODE » button. The number on display
flashes, push MODE again, ON is on display; push MODE
again, OFF is on display; push MODE again, F1 is on
display; push HOUR to select mode (F1/F2/F3). push
MODE to confirm the settings.
F1 - Default one sunrise / sunset with 30 sec
F2 - sunrise/sunset with 10 min
F3 - on/off
Connect the controller to the lighting and ballast
cables, see picture below.
First set the current time: The digital screen will show
12:00 hour, adjust time by pressing MODE button for 3
seconds. The numbers on the screen will flash. Press
HOUR and MINUTE button respectively to adjust to
correct hour and minute.
Set "ON" time: Press MODE again, "ON" will display,
then the time will display and flash. Press HOUR and
MINUTE respectively to adjust to the time you want the
light to turn on.
Set "OFF" time: Press MODE again, "OFF" will display,
then the time will display and flash. Press HOUR an
MINUTE respectively to adjust to the time you want the
light to turn off. Press MODE to finish setting.
ON/OFF switch: Simply short press the MINUTE button
to turn on or off the lighting.
Reset button: Press MINUTE button for 3 seconds, all the
settings will be cleared. The settings will come back to
the default state.
Dimmer: Press the DIM button, "100" is displayed,
adjust the brightness of the light step by pressing the
button (100, 90, 80, 70... 001).
If power is switched off the timer has the memory for
the last of ON and OFF setting, but if the power was off
for more than 6 minutes. The current time needs
adjusting.
Important, the tumble switch in the lighting cable
should be on to allow the Controller to do its work!