Arzum FREESHAKE Bedienungsanleitung Seite 19

FAULT AND DIAGNOSIS
Symptom
Product does not
start
When working , the
blades are stuck
and the white lamp
flashes
Motor burnt smell
Charging without
prompt (red light
not on)
Confirmation matters
•
Is it used continuously for a
long time?
•
Is the food stuck on the blades?
•
Is the host and the juice cup not
rotated in place?
The red light flickered.
•
The fruit pieces are too large and
have caused the blades to become
stuck.
•
Fruits and liquids exceed the
maximum scale rated by the
product.
•
Whether continuous use time
is longer
•
Bad connection to USB data cable.
•
Due to the identification
restrictions of some branded
adapters on the electrical
equipment, the actual output
voltage and current do not meet
the requirements
Take steps
•
Wait for the motor to cool down
before using.
•
Remove the remaining food and
use it again.
•
Install the host and juice cup in
place before starting.
•
Fully charge before use.
•
Make sure that the fruits (apples,
pears, etc.) were washed, peeled
and nucleated, and cut into small
squares of about 1cmx1cmx1cm.
•
Do not let the blades touch the
pulp first, then turn on and put it
in position.
•
Reduce the liquid capacity not
to exceed the rated capacity of
the cup.
•
The high-power motor is inside
the main engine. Due to the friction
of the carbon brush, it will produce
an odor, but not a product fault.
•
Check the connection status of
USB data cable to ensure that the
connection is normal.
•
Charge the product with the
universal adapter of DC5V/1A and
above, which is purchased through
regular channels.
EN
ARZUM 19