Operation; Specifications - Monacor SPEECH -100 D Bedienungsanleitung

3) To connect a signal source with line level
(e . g . mixer, additional receiver for wireless
microphones, CD player): Use the 6 .3 mm
jack of 1 MIC / LINE IN* (5) or the RCA jacks
LINE IN (9) .
When both RCA jacks are connected
(e . g . to the stereo output of a CD player),
the signals will be transformed into a
mono signal .
When speaking into a microphone, it
is possible to mute the signal of an audio
source connected to these jacks (function
☞
VOICE OVER chapter 5) .
4) An additional amplifier system or a
recorder can be connected to the output
LINE LINK (10) . For stereo recorders, two
jacks are available . The amplifier is mono-
phonic; therefore, the signals at the two
jacks are identical .
5) The Speakon -compatible jack EXT .
®
SPEAKER (20) can be used to connect an
additional speaker: Insert the speaker plug
into the jack and then turn the plug clock-
wise until it engages . To remove the plug,
pull back the safety latch on the plug and
turn the plug counter-clockwise .
If required, use the switch INTERNAL
SPEAKER (19) to switch off the internal
speakers .
* Note: The input 1 MIC / LINE IN (5) cannot be used
together with the inputs MIC 1 (2) and MIC 2 (4);
therefore, only use the input 1 MIC / LINE IN when
the inputs MIC 1 and MIC 2 are not required .
4.3 Recharging the batteries
The lectern is operated by means of two
integrated rechargeable lead gel batteries
(12 V/ 7 Ah each) . It is not necessary to switch
on the lectern to charge the batteries; how-
ever, it is possible to use the lectern while the
batteries are being charged .
1) Connect the mains cable supplied to the
mains jack (18) and the mains plug to a
mains socket (230 V/ 50 Hz) .
2) The LED status indicators (14) indicate the
charging state: FULL, OK or LOW . The LED
indicator CHARGE will light up in red while
the batteries are being charged .
3) Once the batteries have been recharged
(the LED indicator CHARGE lights up in
green), disconnect the lectern from the
mains .
Note: To ensure a long life of the rechargeable
batteries, disconnect the lectern from the mains
after a maximum of 12 hours .

5 Operation

1) Prior to the initial switch-on, set all volume
controls (6, 7, 11) to "0" to avoid an un-
expectedly high volume when the lectern
is switched on .
All rights reserved by MONACOR
means for any commercial use.
2) Switch on the audio sources connected
and/or the wireless transmitter .
3) Use the switch (17) to switch on the lec-
tern . The LED indicator PWR ON (16) will
light up . In addition, an LED indicator (14)
will indicate the charging state of the bat-
teries . When the LED indicator LOW lights
up, the batteries should be recharged
( ☞ chapter 4 .3) .
4) Replay music, for example, from an audio
source connected or speak into a wireless
microphone or a cable-connected micro-
phone .
5) Use the appropriate control to adjust the
volume of the audio sources .
LEVEL (6):
2 WIRELESS (7): Wireless microphone
PLAYER (11):
CAUTION To avoid feedback howling,
the volume is too high . In this case, use
the appropriate control LEVEL (6) or
2 WIRELESS (7) to reduce the microphone
volume .
A level limiter will automatically prevent
distortions at high volumes . The LED indi-
cator LIMITER (15) will light up when the
limiter is active .
6) Use the control TONE (8) to adjust the
desired sound for the microphones or for
an audio source connected to the jack
1 MIC / LINE IN (5) . Use the control TONE
(12) to adjust the sound for an audio
source connected to the jack 3 LINE IN (9) .
7) To automatically mute the sound of an
audio source connected to the jacks
3 LINE IN when speaking into a micro-
phone [VOICE OVER (13)], adjust the
control DEPTH in such a way that the LED
indicator MUSIC will light up when an an-
nouncement is being made .
8) To avoid unnecessary discharging of the
batteries, switch off the lectern with the
switch (17) after operation or during
longer pauses .
If the lectern is not used for a longer period of
time, completely charge the batteries prior to
storage and recharge them approx . every six
months to make up for normal self-discharge
and to protect the batteries against damage
due to deep discharge .
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be reproduced in any form or by any
®
Microphones connected
to inputs MIC 1 and MIC 2
or audio source at input
1 MIC / LINE IN
Audio source at input
3 LINE IN
never hold the microphone
towards the speaker or too
close to it . Feedback howl-
ing may also occur when
5.1 Operation with
a wireless microphone
The lectern is equipped with a receiver sec-
tion for a wireless microphone or pocket
transmitter with a transmitting frequency of
863 .05 MHz (e . g . TXS-821HT, TXS-820HSE,
TXS-820LT or TXS-820SX) .
Use the control 2 WIRELESS (7) to adjust
the volume of the audio signal received .
Notes:
1 . If no signal is received from the wireless micro-
phone, make sure that the microphone transmits
on the correct frequency (863 .05 MHz) and check
the battery of the microphone . If required, re-
duce the distance between the lectern and the
microphone .
2 . A poor reception may be improved by turning or
moving the lectern .

6 Specifications

Amplifier
Amplifier class: . . . . . . . . .D
RMS power: . . . . . . . . . . .80 W
Peak power: . . . . . . . . . .120 W
Frequency range: . . . . . . . .70 – 20 000 Hz
Received audio frequency: .863 .05 MHz
Input sensitivity, connection type
☞
(pin configuration fig . 3 on page 2)
MIC 1/ 2*: . . . . . . . . . . . . . 20 mV, bal .
1 MIC IN, XLR*: . . . . . . . . .
1 LINE IN, 6 .3 mm: . . . . . . 13 mV, bal .
3 LINE IN, RCA: . . . . . . . . .100 mV, unbal .
*with 12 V phantom power supply
Outputs
LINE LINK: . . . . . . . . . . . . .RCA, 300 mV
EXT . SPEAKER: . . . . . . . . .Speakon
patible, 4 – 8 Ω
Connection for light: . . . . . .12 V,
100 mA max .
(pin configuration ☞ fig . 3 on page 2)
Power supply: . . . . . . . . . . .rech . lead gel
batteries,
2 × 12 V/ 7 Ah
Operating time: . . . . . . . .up to 16 hours
Mains connection: . . . . . .230 V/ 50 Hz
Dimensions
Width: . . . . . . . . . . . . . . . 525 mm
Height: . . . . . . . . . . . . . . .1120 mm
Depth: . . . . . . . . . . . . . . . 440 mm
Weight: . . . . . . . . . . . . . . .32 .1 kg
Subject to technical modification .
2 mV, bal .
® -com-
7