Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
1) First switch on the receiver only by turning the level control from the left
stop position. Then use the channel selector switch to select a free
transmission channel. If the RF reception indicator lights up or starts
flickering, interference or signals from other transmitters are received. In
this case, use a different channel.
2) Now switch on the transmitter and set it to the receiver's transmission
channel.
Note: Depending on the local conditions, parallel use of up to 4
transmitters possible if you use the following channels: 1, 2, 5 and 16.
3) On the transmitter, adjust the desired volume for the audio signal
transmitted and on the receiver, adjust the desired playback volume.
Caution! Never adjust a very high volume when using earphones.
Permanent high volumes may damage your hearing.
4) To switch off the units after use, turn the level control to the left stop past
the snap-in point. If the units are not used for a longer time, please remove
the batteries.
...............................................................................................................................................
6
TROUBLESHOOTING
Check the following points in case of poor or disturbed reception:
1) Are the (rechargeable) batteries of the units exhausted?
2) Are all components connected correctly?
3) Is the transmission better when a different channel is used?
4) Are transmitter and receiver are too far apart?
5) Are there obstacles in the transmission path which may shield the radio
signal?
17
Werbung
Inhaltsverzeichnis
Fehlerbehebung
