Code HORUS Benutzerhandbuch Seite 4

* We recommend using a regloscope to adjust its projection;
* In some vehicles it may be necessary to install a canceller to erase the missing
bulb information on the dashboard (consult your installer);
* Vehicles that already have an optical projector are not compatible with the HORUS
MEGA LED PROJECTOR.
*Do not open or attempt to repair the item, as this may damage the material and
invalidate the warranty.
*Because it is a high-performance lamp, its structure naturally heats up. If you need
to handle the product after use, wait 5 minutes with it switched off before moving it.
This procedure should only be carried out by a trained professional.
*If installed and adjusted correctly, using a good quality headlight, you will get the
most out of the product; Use original headlights.
*Installation: requires care for certain headlights. The installer must ensure that the
item is installed correctly. In some cases, it will be necessary to modify the vehicle's
original cover to fit the customer's headlight. (Cover not included in the kit).
*The h4 fitting model has a non-polarity system and is compatible with vehicles that
have reversed polarity;
CARE
* Do not look directly into the light, prolonged exposure to an intense light source can
damage your eyesight.
* Please turn off the power when an accident occurs to avoid any possible damage
from voltage leakage caused by separate connectors, etc.
* Do not disassemble or remodel the lamp or the kit. Code will not be held responsible
should this occur.
* Replacements and repairs to parts must not be carried out. For warranty information,
please contact the store where you purchased the product.
* After installation, align the headlights appropriately to prevent the Mega Led Horus
from obscuring the vision of other drivers and pedestrians.
* Do not direct the light upwards, as this will impair the safety of drivers in the opposite
direction.
* Keep the product away from non-flammable products.
* Use original fittings and wires to power the LED lamp.
* Respect the fitting configurations. Only install the LED lamp with its corresponding
fitting (do not adapt).
03