Command Warnings; Caution On Battery Use; Battery Installation - Create Tv Color Studio Benutzerhandbuch

CO M M A ND WA R NI NGS
• Use the remote control by pointing it at the remote sensor on the TV. If there are elements
between the remote control and the sensor, they may interfere with the normal operation of
the remote control.
• Do not vibrate the controller violently. Do not splash liquids on the controller or place it in a
place where there is high humidity.
• Do not expose the controller to direct sunlight, the heat may warp and damage the unit.
• If the TV's remote sensor is under direct sunlight or strong lighting, the remote control will not
work. If this happens, change the lighting in the room or the position of the TV, or move the
remote closer to the remote sensor.
• To perform Bluetooth pairing, make sure you have enabled external Bluetooth devices in pair-
ing mode. Press the back buttons
pairing mode.
• From the TV panel, you can press the microphone icon to quickly pair your TV's Bluetooth.
CAU T IO N O N BAT TE RY USE
Improper use of batteries may cause leakage. Follow the following instructions and use them
carefully:
• Please note the polarity of the batteries to avoid short circuits.
• When the battery voltage is insufficient and affects the range of use, you should replace the
batteries with new ones.
• Remove the batteries from the remote control if you will not use it for an extended period of
time.
• Do not use different types of batteries together, for example, manganese and alkaline batteries.
• Do not throw batteries into fire, charge them, or destroy them.
• Dispose of batteries in compliance with relevant environmental protection regulations.
• Batteries should not be exposed to excessive heat temperatures such as sunlight, fire or the like.
• A battery subjected to extremely low air pressure may cause an explosion or leak of flamma-
ble liquid or gas.
BAT T E RY I N STA L L AT I ON
1. Remove the back cover of the remote control.
2. Place two AAA size batteries in the battery compartment of the remote control. Making sure
to match the polarity markings inside the compartment.
3. Replace the back cover of the remote control correctly.
10 E NGL I SH
+ at the same time on the remote control to open the