Replacing The Battery - Bushnell First Strike 730005 Benutzerhandbuch

Point of Impact Change Chart
Distance
25 yds
50 yds
100 yds
Distance
25 yds
50 yds
100 yds

REPLACING THE BATTERY

Y
our new Bushnell First Strike electronic sight is
powered by one 3V "coin-style" lithium battery, Type
2032 (I) (pre-installed). Should your reticle grow dim
or not light at all, you will need to replace the battery.
To install a new battery, use the provided small hex
wrench (M) to loosen the two bolts (G) on the top
panel. Remove the top section of the sight and insert
the battery "+" side up as shown in the Parts Guide.
Replace the top section and tighten the bolts (G).
8
1 Full Revolution of Adjustment Screw
12.5 inches
25 inches
50 inches
1 Hash Mark of Adjustment Screw
1.5 inches
3 inches
6 inches