Allard Selection Back Regular Gebrauchsanweisung Seite 2

EN
35401 SELECTION BACK REGULAR
Carefully read this instruction sheet before use!
Intended Use
Selection Back Regular is intended to be used for moderate Low Back
Pain and weakness. It can also be used to support the spine during
heavy lifting.
Indications
Low Back Pain, Back insufficiency. Single Patient-multiple use.
Contraindications
Sciatica with leg or foot numbness or weakness.
Adjustment
This product should only be altered by a medical professional person.
Warning
Do not pull the straps too tight, as this can cause poor circulation
and/or skin irritation. If you feel any irritations or other problems,
take it off immediately. Check skin on a daily basis.
How to use the support
Check that you have the correct size. Some conditions can result in
swelling that can mean variations in size. If this is the first time you
are using a support it is important to start slowly. Use the support for
a short period of time the first day, then increase the use gradually.
The support should not be used overnight.
Material specifications
72% Polyester, 28% Spandex. Stays, Velcro and buckles made of
nylon. This product does not contain Latex. This product is not flame
retardant.
Wash instruction
Close all Velcro prior to laundering. Machine washable in 40°C
(104°F). Dry flat. Do not tumble dry or dry clean. Use a washing bag.
Disposal
Disposal in accordance with local legislation.
Information
Any serious incident that may occur in relation to the device should
be reported to the manufacturer and the competent authority of the
Member State in which the user and / or patient is established.
Who to contact
If any problems occur please contact your orthotist or fitter.
Instructions for use
1. Check that the support is complete and without damage.
2. Loosen the two stabilizing straps so that the cross in the back
becomes loose.
3. Put the support around your body and secure that it is centered
over the spine. Then put one hand/fingers in the pocket and the
other into the strap and pull forward to close on the front.
4. Grab hold of the two stabilizing straps, pull them forward and
secure on the front.
5. To remove the support: First open the two stabilizing straps.
6. The open the front velcro closure.