Connecting The Optional Ac Adapter; Installing The Thermal Paper - Texas Instruments Pc-324 Bedienungsanleitung

procedure.
Slide the top cover off the printer
access the battery compartment.
Remove any depleted batteries from
the compartment.
Install the batteries as shown in the
Figure I.
Be sure all of the batteries are positio-
ned correctly. Installing a battery back-
wards may damage the printer.
Replace the battery cover.
that you use alkaline
in your printer. If non-alkaiine
must be used, remove the batteries
the Optional
AC9201!E adap-
the printer on standard
provides power not
but also for the cal-
4
To connect the AC adapter, follow these
steps :
to I. Connect the adapter
on the back of the printer.
2. Plug the adapter into any standard AC
outlet.
Installing the Thermal
To help you to identify
about to run out of paper, the last few feet
of every paper roll is marked with a colo-
red stripe.
Installing or Replacing
1. Slide the top cover off the printer to
bat-
access the paper compartment.
batte-
the cover is off, do not tear the paper
against the output
mechanism.
2. If you need to remove a partially
roll, tear the paper at the input side of
the mechanism.
when handling the partial roll to pre-
line
vent it from unwinding.
cord to the socket
Paper
when the printer is
the paper
While
side of the
used
Some care is required
5