smartmi VortexWave Bedienungsanleitung Seite 15

Use
Removing the limit strip
Place the robot on a flat indoor surface
and remove the protective limit strip
installed on the inner side of the front
bumper.
Adding water to the water tank
Unfasten the flip cover buckle to
1
open it as shown in the figure.
Warning: In order to prevent damage to the robot, turning the robot over before the water tank has been
removed is strictly prohibited!
Take out the
limit strip
Hold the handle of the water tank to
2
take it out.
10
Open the water tank filling cap, add
3
clean water or solution to the water
tank filling hole, and then close the
water filling cap.
Water tank
filling hole
Put the water tank back in place,
4
level the water tank handle, and
then close the flip cover.
Water
filling cap