Timago TGR-R RS 8812 Benutzerhandbuch Seite 21

3. Assembly
UNFOLDING
• Place the walking table on the ground. Fix the upper stabilizing frame in the
moun�ng openings in the front part of the frame and �ghten with moun�ng
screws.
• Mount the forearm support into the moun�ng openings on the frame and
secure it with locking clips on the chosen height.
• Fix the seat onto the lower frame part. Use the seat for temporary rest.
Note! While using the seat, all the brakes should be locked.
• When walking, the seat should be hung on the outer side of the frame.
• In case of using IV stand, place it in the IV stand holder in the front part of
the frame.
HEIGHT ADJUSTMENT OF FOREARM SUPPORT
The height of the forearm support should be adjusted so that the user can stand
as upright as possible, with shoulders relaxed and elbows res�ng comfortably on
the supports. It is not advisable to place full body weight on the walking table.
• To adjust the height of forearm supports, pull out the locking clip which is
located on the outer side of the frame, select appropriate height and fix the
clip again.
4. Technical data
Seat dimensions
Seat height from the ground
Forearm support height
Maximum capacity
5. Notes
Timago Interna�onal Group does not bear responsibility of improper use of the
product, failure to comply safety regula�ons and misuse.
Overall width
Overall depth
adjustment
Weight
56 x 20 cm
101-124 cm
10,8 kg
100 kg
21
63 cm
76 cm
54 cm