Rebel COMP RB-4023 Bedienungsanleitung Seite 7

3. Placement
Install the UPS unit in any protected environment that provides adequate airflow around the
unit, and is free from excessive dust, corrosive fumes and conductive contaminants. Do not
operate your UPS in an environment where the ambient temperature or humidity is high.
On the other hand, place the UPS away from the monitor at least 20cm to avoid interference.
4. Connection
Plug the UPS into a 2-pole, 3-wire grounded receptacle. Then connect one computer-
related device into each of the power receptacles supplied on the back of the UPS.
5. Turn On/Off
To turn on the UPS unit, press the power switch lightly. To turn off the UPS unit, press the power
switch again.
EN
Power switch
12
6. Mute sounds
To mute the alarm sound, double-press the Power button while the device is on. To turn it back
on, repeat the action. After restarting the device, the alarm sound will be enabled by default.
7. Application
The app for UPS management
https://www.power-software-download.com/viewpower.html
SPECIFICATION
Model
POWER VA/W
Voltage
INPUT
Voltage Range
Voltage Regulation
(Batt. Mode)
Frequency
OUTPUT
Frequency Regulation
(Batt. Mode)
Output Waveform
Battery Type
BATTERY
Recharge Time
Typical
TRANSFER
TIME
Maximum
Backup Mode
Low Battery
AUDIBLE
ALARM
Overload
Fault
PROTECTION Full Protection
PHYSICAL Dimensions (mm)
WEIGHT Net Weight (kg)
Operating Environment
ENVIRONME
NT
Noise Level
can be downloaded
RB-4020/RB-4023 RB-4021/2/4/5
850 VA / 480 W
650 VA / 360 W
1000 VA / 600 W
230 VAC
140-300 VAC
+/-10%
50 Hz or 60 Hz
+/-1 Hz
Modified Sine wave
12 V / 7.0 AH x1 12 V / 9.0 AH x1
6-8 hours to 90% after complete discharge
2-6 ms
10 ms
Sounding every 10 seconds
Sounding every 1 second
Sounding every 0,5 second
Continuously sounding
Discharge, overcharge, and overload protection
297 x 101 x 142
4,2 4,9
0°C - 40°C
Less than 40 dB
13
here:
EN