BLUETTI consiglia di usare accessori originali BLUETTI. BLUETTI non sarà responsabile di eventuali danni o spese derivanti dall’uso di pezzi diversi da quelli originali BLUETTI. Per la sicurezza e a vantaggio dell’utente, leggere attentamente il manuale prima dell’utilizzo e ...
Istruzioni di sicurezza La mancata osservanza delle presenti linee guida può causare danni all’unità e lesioni all’utente o ad altri. Tenere l’unità lontana da fuoco, umidità e polvere. Assicurarsi che il luogo di utilizzo dell’unità sia ben ventilato e spazioso. ...
Contenuto Confezione standard Power Station Adattatore CA Cavo di ricarica per automobile Cavo di ricarica solare Manuale Scheda di garanzia utente * Adattatore CA: 120 cm/47 pollici. Cavo di ricarica per automobile: 72 cm/28 pollici. Porta accendisigari DC7909. Cavo di ricarica solare: 150 cm/59 pollici. Da MC4 a DC7909. Nota: i dettagli del pacchetto sono soggetti a modifica senza preavviso.
Panoramica del prodotto Schema 1. Porta di ricarica 7. Porta USB-C 2. Schermo LCD 8. Porta USB-A 3. Pad di ricarica wireless 9. Porta DC5521 4. Pulsante lampadina LED 10. Porta accendisigari 5. Lampadina LED 11. Pulsante alimentazione CA 6. Pulsante alimentazione 12.
Specifiche EB70 Generale Capacità della batteria 716 Wh Tipo di cella LiFePO4 Dimensioni (L*P*A) 320*216*221 MM/12,6*8,5*8,7 POLLICI Peso 9,7 KG/21,4 LB Temperatura di scarica da -20 a +40 °C/da -4 a +104 °F/ Temperatura di carica da 0 a 40 °C/da 32 a 104 °F Umidità...
Funzionamento Schermo LCD a: modalità ECO e: allarme anomalia di b: capacità della temperatura batteria f: alimentazione di uscita c: alimentazione di g: allarme sovraccarico ingresso h: allarme corto circuito d: allarme batteria scarica Accensione/Spegnimento Accensione: premere il pulsante di accensione CA/CC per attivare l’uscita corrispondente. Luce verde (sul pulsante) Display LCD *Lo schermo LCD si accende per circa 30-60 secondi.
“Impostazione modalità”, premere il pulsante di alimentazione CA per accendere. Ricarica Ricarica CA Inserire EB70 nella presa a muro standard e avviare la ricarica. Presa CA Adattatore La spina del caricabatterie DEVE essere inserita completamente nella porta di ricarica dell’apparecchiatura.
Seite 11
Ricarica PV Collegare i pannelli solari (in serie o in parallelo) a EB70 tramite il cavo di ricarica solare. Nota: accertarsi che i pannelli solari siano conformi a : 12-28 V Corrente di ingresso: 8 A Max. Alimentazione di ingresso: 200 W Max.
Ricarica del generatore Collegare la spina di ingresso dell’adattatore CA al generatore e inserire la spina di uscita nella porta di ricarica di EB70. Scarica Televisione Smartphone Lampadina LED Circa 7-8 ore Circa 50-60 volte Circa 20-30 ore 75 W...
R: Sì. Premere il pulsante di accensione CC per abilitare la ricarica wireless. D: È possibile caricare e scaricare contemporaneamente? R: Sì. Consente la ricarica passante. EB70 è dotata di una batteria LiFePO4 premium e di un sistema di gestione della batteria brevettato volto a garantire la ricarica e la scarica contemporaneamente.
Assistenza tecnica In caso di ulteriore assistenza, non esitare a contattare il team di assistenza BLUETTI. BLUETTI POWER INC Sito web: https://www.bluettipower.com/ Tel: +1 833 9883663/702 4634792 E-mail: service@bluettipower.com Indirizzo: 6185 S Valley View Blvd Ste D. Las Vegas, NV 89118. - U.S.A.
Seite 16
Thank You Thank you for making BLUETTI a part of your family. From the very beginning, BLUETTI has tried to stay true to a sustainable future through green energy storage solutions for both indoor and outdoor use while delivering an exceptional eco-friendly experience for our homes and our world.
Seite 17
CONTENTS Before You Begin Safety Instructions What's In The Box Standard Packaging Product Overview Diagram Specifications Operation LCD Screen Powering On/Off Mode Setting Charging Discharging Appendix FAQs (Frequently Asked Questions) Technical Support...
The user manual contains instructions and notes on the operation and use of this unit. BLUETTI recommends that you use genuine accessories from BLUETTI. BLUETTI shall not be responsible for any damage or expense that might result from the use of parts other than genuine parts from the BLUETTI.
Safety Instructions Failure to follow these guidelines may cause damage to your unit and injury to yourself or others. Keep this unit away from fire, humidity and dust. Make sure the place where you are using the unit is well ventilated and spacious. DO NOT place the unit on an unstable or tilted surface.
What's In The Box Standard Packaging Power Station AC Adapter Car Charging Cable Solar Charging Cable User Manual Warranty Card * AC Adapter: 120cm/47in. Car Charging Cable: 72cm/28in. Cigarette lighter port to DC7909. Solar Charging Cable: 150cm/59in. MC4 to DC7909. Note: Package details are subject to change without prior notice.
Product Overview Diagram 1. Charging Port 7. USB-C Port 2. LCD Screen 8. USB-A Port 3. Wireless Charging Pad 9. DC5521 Port 4. LED Lamp Button 10. Cigarette Lighter Port 5. LED Lamp 11. AC Power Button 6. DC Power Button 12.
Specifications EB70 General Battery Capacity 716Wh Cell Type LiFePO4 Dimensions (L*W*H) 12.6*8.5*8.7IN/320*216*221MM Weight 21.4LB/9.7KG Discharging Temperature -4-104°F/-20-40°C Charging Temperature 32-104°F/0-40°C Working Humidity 10-90% AC Output 120V 800W Power 220-240V 1000W Surge 1400W Frequency 50-60Hz DC Output Voltage 12VDC Cigarette Lighter Port *1...
Operation LCD Screen a: ECO Mode e: Temperature Anomaly Alert b: Battery Capacity f: Output Power c: Input Power g: Overload Alert d: Low-battery Alert h: Short-circuit Alert Powering On/Off Powering on: Press the AC/DC Power Button to start up corresponding output. Green light(on the button) LCD Display *The LCD screen is on for about 30-60 seconds.
: Under 'Setting Mode', press the AC power button to switch. Charging AC Charging Simply plug the EB70 into a standard wall outlet and start charging. AC Outlet AC Adapter When on this mode, the AC output will automatically turn off after 4-hour low (≤10W) or no load to save power.
Seite 25
Solar Charging Cable Car Charging Connect the EB70 directly to the vehicle plug-in cigarette lighter port via the car charging cable. Car Charging Cable OCV: Open circuit voltage. The maximum voltage that the solar panel can produce with no load on it.
Generator Charging Connect the AC adapter input plug to the generator while the output plug goes to the charging port of EB70. Discharging 10Wh Television Smart Phone LED Light Bulb Around 50-60 Times Around 20-30 Hrs Around 7-8 Hrs 10Wh...
A: Yes. Press the DC Power Button to enable the wireless charging. Q: Can it charge and discharge at the same time? A: Yes. It supports pass-through charging. EB70 comes with the premium LiFePO4 battery and proprietary Battery Management System to ensure that it can charge and discharge at the same time.
Technical Support Should you require any further assistance, please do not hesitate to contact BLUETTI service team. BLUETTI POWER INC Web: https://www.bluettipower.com/ Tel: 833-988-3663 / 702-463-4792 Mail: service@bluettipower.com Add: 6185 S Valley View Blvd Ste D. Las Vegas, NV 89118.
Innen- und Außenbereich treu zu bleiben und gleichzeitig ein außergewöhnliches und umweltfreundliches Erlebnis für Ihr Zuhause und unsere Welt zu bieten. Aus diesem Grund ist BLUETTI in über 70 Ländern präsent und genießt das Vertrauen von Millionen von Kunden auf der ganzen Welt.
Seite 31
Inhalt Bevor Sie beginnen Sicherheitshinweise Lieferumfang Standard Set Produktübersicht Schaubild Spezifikationen Bedienung LCD-Display Ein-/Ausschalten Modi Einstellung Laden Entladen Anhang FAQs (Häufig gestellte Fragen) Technischer Support...
Geräts. BLUETTI empfiehlt die Verwendung von Originalzubehör von BLUETTI. BLUETTI haftet nicht für Schäden oder Kosten, die sich aus der Verwendung von anderen Teilen als den Originalteilen von BLUETTI ergeben könnten. Bitte lesen Sie diese Anleitung zu Ihrer eigenen Sicherheit vor der Verwendung sorgfältig...
Sicherheitshinweise Die Nichtbeachtung dieser Richtlinien kann zu Schäden an Ihrem Gerät und Verletzungen bei Ihnen oder anderen führen. Halten Sie dieses Gerät von Feuer, Feuchtigkeit und Staub fern. Stellen Sie sicher, dass der Ort, an dem Sie das Gerät verwenden, gut belüftet und geräumig ist. Stellen Sie das Gerät NICHT auf eine instabile oder geneigte Oberfläche.
Lieferumfang Standard Set Powerstation Netzteil Kfz Kabel Solar-Ladekabel Bedienungsanleitung Garantiekarte * Netzteil: 120cm. Kfz Kabel: 72cm Zigarettenanzünderanschluss auf DC7909. Solar-Ladekabel: 150cm/59in. MC4 to DC7909. Hinweis: Paketdetails können ohne vorherige Ankündigung geändert werden.
Betrieb LCD-Display a: ECO-Modus e: Warnung bei Temperaturanomalie b: Batteriekapazität f: Ausgangsleistung c: Eingangsleistung g: Überlastungswarnung d: Warnung bei schwacher Batterie h: Kurzschlusswarnung Ein-/Ausschalten Einschalten: Drücken Sie die Wechselstrom-/Gleichstrom-Taste, um den entsprechenden Ausgang zu starten. Grünes Licht (auf der Taste) LCD-Display EIN* *Der LCD-Bildschirm ist etwa 30-60 Sekunden lang eingeschaltet.
: Drücken Sie im „Einstellungsmodus “ die AC-Netztaste, um umzuschalten. Aufladen Wechselstrom Schließen Sie das EB70 einfach an eine normale Wandsteckdose an und beginnen Sie mit dem Aufladen. Netzsteckdose T200S 200W Netzteil In diesem Modus schaltet sich der AC-Ausgang automatisch nach 4 Stunden niedriger Leistung (≤10 W) oder ohne Last aus, um Energie zu sparen.
Seite 39
PV-Laden Schließen Sie die Solarmodule (in Reihe oder parallel) über das Solarladekabel an EB70 an. Hinweis: Bitte stellen Sie sicher, dass Ihre Solarmodule folgende Anforderungen erfüllen: : 12-28V Eingangsstrom: 8 A max. Eingangsleistung: 200 W max. MC4 Verbinder Solarladekabel Aufladen im Auto Schließen Sie die EB70 über das Kfz-Ladekabel direkt an den Zigarettenanzünderanschluss des...
Laden mittels Generator Verbinden Sie den Eingangsstecker des Netzteils mit dem Generator, während der Ausgangsstecker mit dem Ladeanschluss des EB70 verbunden ist. Netzteil Entladen 10Wh Fernseher Smartphone LED-Glühbirne 50–60 mal Etwa 20–30 Std. Etwa 7–8 Std. 10Wh Elektrowerkzeuge Kühlschrank Kochgerät Etwa 7–8 Std.
A: Ja. Klicken Sie auf die DC-Einschalttaste, um das kabellose Laden zu aktivieren. F: Kann es gleichzeitig laden und entladen? A: Ja, das „Pass-Through-Laden “ wird von dem Gerät unterstützt. Die EB70 wird mit einem hochwertigen LiFePO4-Akku und einem ausgereiften Batteriemanagementsystem ausgeliefert, um sicherzustellen, dass sie gleichzeitig geladen und entladen werden kann.
Technischer Support Sollten Sie weitere Hilfe benötigen, wenden Sie sich bitte an das BLUETTI-Serviceteam. BLUETTI POWER INC Internet: https://www.bluettipower.eu E-Mail: sale-eu@bluetti.com Lindwurmstraße 114, 80337 München, Germany. Company: POWEROAK GmbH Address: Lindwurmstr. 114, 80337 München Germany Mail: logi@bluetti.de Company: POWEROAK ENERGY UK CO.,LTD...