Yealink RCH80 Bedienungsanleitung Seite 6

Interface Introduction
1 System Light
2 Gigabit Electrical Port Light
3 GSFP Port Light
4 Gigabit Electrical Port
5 GSFP Port
6 CLI Port
7 Reset
8 PoE Light
9 Power Light
1 2 3
9 8
10 11
Indicates the current system status.When the RCH80 is in normal use, its indicator light will
blink.
Indicates whether the Gigabit Electrical Port has signal transmission and the transmission
speed.
Indicates whether the GSFP port has signal transmission and the transmission speed.
8 x RJ-45 POE+ ports.
2 x GSFP ports.
The RJ45 port with a rate of 9600bps, is used for serial connection to PC or endpoints to moni-
tor and configure the RCH80.
After powering on, hold the button for 6s to reset RCH80 into factory defaults.
Indicates whether a PD (Powered Device) is connected and if power is being supplied.
Indicates the power status of the RCH80. The indicator light will illuminate once powered on.
4
7
4
5 6