Diadora RACER 18 Bedienungsanleitung Seite 15

FIG.3
FIG.4
OPERATING INSTRUCTIONS
FIG.3:
First, the elastic bolt (7) of the large ball head is
relaxed and pulled down. Then, the armrest
regulating tube assembly (17) is inserted into the
inter-tube bushing of the main frame assembly
(16) to make it in proper position. Then, the elastic
bolt (7) of the large ball head is released and
locked.
The armrest tube assembly (18) is then fixed on
the armrest regulating tube assembly (17) with a
light elastic washer (24), a flat gasket (25) and an
inner hexagonal cylindrical screw (23), and the
armrest tube assembly (17) is locked. Finally, the
armrest cover (26) is clipped to the armrest tube
assembly (18).
ATTENTION: YOU SHOULD FIX THE HANDLEBAR
TIGHTLY
With the cross recessed pan head screw (41),
adjust the electronic watch base (80) to the
appropriate position and lock it on the armrest
tube assembly (18); Then the
buckle to the electronic watch base (80),
respectively connected A1&A2,A3&A4.
FIG.4:
The Pedals (pt.1 L & pt.1 R) are marked "L"
and "R" - Left and Right.
Connect them to their appropriate crank
arms. The right crank arm is on the right-
hand side of the cycle as you sit on it.
Note that the Right pedal should be
threaded on clockwise and the Left pedal
anticlockwise.
6
electronic watch (81)