Assembly Instruction - Diadora Racer 18 Bedienungsanleitung

ASSEMBLY INSTRUCTION:

1.PREPARATION:
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above of this instruction sheet you will find
an explosion drawing with all single parts (marked with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTION:
:
FIG.1
FIG.2
OPERATING INSTRUCTIONS
FIG.1:
Attach the Front Stabilizer (pt.15) to the
Main Frame (pt.16) using two sets of Ø8 Flat
Washers (pt.5), M8 Domed Nut (pt.6) and
M8*52 Carriage bolt (3).
Attach the Rear Stabilizer (pt.4) to the Main
Frame (pt.16) using two sets of Ø8 Flat
Washers (pt.5), M8 Domed Nut (pt.6) and
M8*52 Carriage bolt (3).
FI G.2:
First, the elastic bolt (7) of the large ball head
is loosened and pulled down, then the cushion
adjusting pipe assembly (10) is inserted into
the inner liner of the main frame assembly (16)
to make it in an appropriate position, and then
the elastic bolt (7) of the large ball head is
loosened and locked. At the same time, the
buffer sliding tube assembly (12) is inserted
into the buffer regulating tube assembly (10)
and the elastic bolt (7) of the large ball head is
locked by the buffer. Finally, the buffer pad
(13) is locked with a tool (using a cross
wrench).
5