Herunterladen Inhalt Inhalt Diese Seite drucken

Kromer KHG-PS-50 Bedienungsanleitung Seite 36

Pelletofen feuerleistung 7,2kw, po-7
Inhaltsverzeichnis

Werbung

Geprüfte Qualität
If the room temperature exceeds the setting temperature, the stove automatically switch
shown on screen. After the stove is completely cool down, "Standby" will be shown on
Einstelllung Reinigung
again until you switch it on manually.
Hinweis
Die Einstellung „Clean Combustion" sollte in der hohen Intensität (100) beibehalten werden.
CLEANING SPEED
It is suggested to keep " Clean Speed " at high speed. Do not make adjustment.
Einstellung Abgas Geschwindigkeit während des Zündvorganges
EXHAUST BLOWER SPEED for Igniting
Die Abgasgeschwindigkeit ist optimal einge-
In regular condition, the Exhaust Blower Speed doesn't need to be adjusted if the Ex
stellt und sollte nicht geändert werden. Die-
installed. Exclude the problem on Exhaust Venting System, if the fire can not be ignite
se Einstellung darf nur in Rücksprache mit
exhausted out during Start-up procedure, the Exhaust Blower Speed for Igniting Stage
dem Hersteller geändert werden, falls der
Zündvorgang nicht funktioniert.
There are following reasons that the fire can not be ignited or the smoke in firebox
Bei folgenden weiteren Ausnahmen muss
Start-up procedure:
eine Änderung vorgenommen werden:
1. Low Voltage in certain area or different countries.
2. Higher altitude.
(1) bei Niedrig-Spannung (kleiner als 220
3. Low atmospheric pressure.
Volt)
4. Long Exhaust Venting system.
(2) Hohen Höhenlagen
(3) Niedrigen Atmosphären Druck
(4) Hohe Abgas Druckentlastung
Press the " Setting key "
following menu will be shown on screen.
36
© Krömer-Pelletofen 2011
Pelletofen
Reifenmontiermaschinen
CMYK
80, 20, 0, 40
RAL
5007 Brillantblau
Pantone 5405
Elektro-Fahrräder
CMYK
0, 50, 100, 0
.
RAL
1007 Narzissengelb
Pantone 137
with a beep, get into Setting Menu. Keep pressing
Ka ee-Maschinen
CMYK
0, 82, 85, 62
RAL
8029 Perlkupfer
Pantone 175
Farbtabelle
Stand 05.07.2011
Farben weichen je nach Farbsystem
(CMYK, RAL oder Pantone) voneinander
ab. Je nach Druckuntergrund sollte die
Farbgebung überprüft werden, da
Abweichungen möglich sind.
Wuchtmaschinen
CMYK
RAL
Pantone 5405
Drücken Sie bitte den
„Systemschlüssel"
Elekro-Motorräder
Nach dem ein kurzes Ton-Signal ertönt ist,
befi nden Sie sich im Einstell-Menü. Drücken
CMYK
Sie den Systemschlüssel mehrere Male bis
RAL
Sie in das Menü „Light Combustion" gelan-
Pantone 137
gen.
Türen
CMYK
RAL
Pantone 7502
80, 20, 0, 40
5007 Brillantblau
0, 50, 100, 0
1007 Narzissengelb
0, 11, 42, 14
1002 Sandgelb

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis