Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Code
Parameter description
d1
Switching hysteresis for setpoint 1 (relais 1)
*
d2
Switching hysteresis for setpoint 2 (relais 2)
LS1
Lower limit temperature for setpoint 1
*
LS2
Lower limit temperature for setpoint 2 (alarm)
HS1
Upper limit temperature for setpoint 1
*
HS2
Upper limit temperature for setpoint 2 (alarm)
od
Switching delay for output relay in seconds
CAL
Zero reset, compensation for sensor tolerances and system deviations
*
Ft
Internal functions must be on
PSE
Sensor selection Pt 100/Ni 100
*
OCO
Relay 1 and 2 dependent upon each other/Relays 1 and 2 independent of each other
HC1
Relay 1 switches when the temperature falls
Relay 1 switches when the temperature rises
*
HC2
Relay 2 switches when the temperature falls
Relay 2 switches when the temperature rises
rP1
Relay 1 opens on sensor failure/Relay 1 closes on sensor failure
rP2
Relay 2 opens on sensor failure/Relay 2 closes on sensor failure
LF1
LED 1 illuminates when relay 1 is energised/LED 1 extinguishes when relay 1 is energised
*
LF2
LED 2 illuminates when relay 1 is energised/LED 2 extinguishes when relay 1 is energised
dP
Switch on decimal point/See note on decimal point
hdd
Absolute value displayed (50, 51, 52)/Display rounded off (50, 55, 60)
tAb
Factory setting cannot be altered
14
Range
- 99 °C to 799 °C
- 99 °C to 799 °C
- 99 °C to HS1
- 99 °C to HS2
+ 700 °C to LS1
+ 700 °C to LS2
0 to 500 sec.
- 99 °C to 999 °C
Pt/ ni
di/ni
C
H
C
H
ro/rc
ro/rc
di/in
di/in
on/of
n/y
* Only for versions with two outputs
Werbung
