Audizio RP325W Bedienungsanleitung Seite 4

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must
be returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
1. Multi-function knob
Phono, BT in, BT out, stand-by and volume knob.
Short press to turn on the turntable. Short press (while on) to
change
mode. Long press to enter standby function.
2. Indicator light for function
The indicator light is only blue. It will be solid or flashing when
the PHONO, BT IN, or BT functions are active.
3. Power jack connect included adaptor 12V, 2A
Connect the included 12V, 2A adapter here to power the turntable.
4. Speaker out jack -R channel
The audio output from a playing vinyl record is sent to this line-level
coaxial audio output. This must be connected to phono level devises.
5. Speaker out jack -L channel
The audio output from a playing vinyl record is sent to this line-level
coaxial audio output. This must be connected to phono level devises.
6. Platter
Place your record here
7. 45 RPM adaptor
This adaptor allows you to play 45RPM records.
8. Tonearm lever
Use to raise/lower the tone arm.
9. Auto-stop switch
When set to ON, the platter stops automatically at the end of the record.
If playback stops too early, set the switch to OFF to disable auto-stop.
10. Speed switch
Use the speed switch to select the correct platter speed:
33 1/3, 45, or 78 RPM, depending on the type of record being played.
11. Tonearm
The tonearm holds the needle and guides it smoothly across the record.
12. Tonearm clip
This arm clip secures the tone-arm while at rest or when not in use.
13. Cartridge with needle
When the turntable is not in use, it is recommendable to place
the removable protection cover over the stylus.
Note: This device will help you to save power consumption with the ERP energy saving standard. When there is no audio
input for 20 minutes, power will automatically cut-off. To turn power back on and resume playing, you will need to short
press multi-function knob to turn it on again.
1. Connect the record player with the power adapter and plug the other end into a wall power outlet.
2. Gently remove the protective needle cover.
3. Rotate the volume control knob to just above the minimum level and turn on the power.
4. Short press the multi-function knob to PHONO mode. You will hear prompt voice to remind you enter PHONO mode (Note:
The indicator light will be solid Blue).
5. Place a vinyl record on the turntable platter and select the desired speed (33/45/78RPM) according to the record.
Use the 45rpm adapter if necessary.
6. Open the tone arm clip to release the tone arm. Push the lift lever backwards to raise the tone arm and gently move the
tone arm to the desired position over the record. The turntable will begin to spin when the tonearm is moved towards the
record. Push the lift lever forwards to lower the tone arm slowly onto the desired position on the record to start playback.
7. Rotate the volume control knob to adjust the volume.
4