BRAX GX2000 Bedienungsanleitung Seite 21

The control range extends from 1.0 V (maximum CW) to 8.0 V (maximum CCW).
10 Operation mode switch
10
Operation mode switch for channels A/B
MONO BRIDGED
STEREO BRIDGED 10
STEREO
CHANNEL A/B
To select the mode of the amplifier. This switch is located on the bottom of the amplifier.
Stereo: Select the STEREO MODE for using the channels A/B in a 2-channel mode. In this configuration both level con-
trols are activated to adjust the input sensitivity.
Stereo Bridged: Select the stereo bridged mode for using the channels A/B in the mono mode. In this configuration both
channels are bridged to one channel (mono). At position STEREO BRIDGED both signal inputs of the channels A/B
have to be used. In this configuration both level controls are activated to adjust the input sensitivity. The controls should
be set to the same position.
Mono Bridged: Similar as in mode stereo bridged the amplifier is switched to mono and both channels will be bridged
to one channel. If you select MONO BRIDGED only the input A has to be used. This can be necessary if there is only
one mono signal available. In this configuration only level control A is activated to adjust the input sensitivity of the bridged
channel pair.
21