Device Description - Netio 4 Installations Anleitung

Device description

The front
1. Switched outlets (outlet type varies according to region).
2. LED indicators.
3. Buttons for switching the outlets on and off manually.
4. LED indicators for Wi-Fi and Bluetooth (Bluetooth applicable only to NETIO4 All).
5. Power cable with a mains power plug.
6. RP-SMA connectors for connecting two supplied antennas (NETIO4 All only).
7. Fixed 3 dBi omnidirectional Wi-Fi antenna (NETIO4 only).
NETIO4 All
6
NETIO4
7
The side
1. Resettable fuse button.
2. Main power switch.
3. RJ-45 connector for connecting to a computer network.
Connecting the NETIO4/NETIO4 All device
1. Attach two supplied antennas to the device (NETIO4 All only).
2. Connect NETIO4/NETIO4 All to a computer network with the Ethernet cable and/or use Wi-Fi, see below.
3. Connect NETIO4/NETIO4 All to the power supply with the power cable.
4. Connect the chosen device to the desired outlet.
5. Switch on NETIO4/NETIO4 All with the power switch on the side.
Note: the first power-up can take a few minutes due to the initial configuration of the firmware.
1
1
8
4
2
3
4
2
3
2
3
1
5
5