netio 4 Installations Anleitung Seite 12

Overview of the functions of LEDs, buttons and sound signals
LED indicators [1] to [4]
Device power-up
Standard mode
Maintenance mode
Reset to factory settings in progress
Firmware upgrade in progress
Output states (outlets)
Locate function
DHCP failure
LED indicators for Wi-Fi and Bluetooth (Bluetooth only on NETIO4 All)
Active
Inactive
Problem
Button functions
Rocker switch
Outlet controls [1] to [4]
Restart in maintenance mode
Reset to factory settings
Sound signals
Device power-up
Request to restart in maintenance mode received
Request to reset to factory settings received
Reset to factory settings complete
Resettable fuse - the device is equipped with a resettable fuse. If a connected device has a defect or an outlet
is overloaded, the power supply will be shut off. As a result, the fuse button will come out. After the defect has been
removed (the faulty load disconnected) and 30 - 60 seconds have elapsed, you can press this button to return the device
to the original state.
[1] to [4] reds are on
[1] to [4] are off (or solid green if an outlet is switched on)
[4] red is on
[1] to [4] blinks red
[3] blinks red, [4] is solid red
The LED indicating an active outlet is solid green; blinks green
during power-up; is off when the outlet is switched off
[1] blinks red
[2] red is on
Is lit
Light is out
Blinks
On/off
To switch on/off, press the button and hold it for 2 seconds
On power-up, press button [4] and hold it until the device beeps twice
On power-up, press buttons [1] and [2] and hold them until the
device beeps twice
One beep
Two beeps
Two beeps
Two beeps
11