Meec tools 029845 Bedienungsanleitung Seite 6

1 Introduction
EN
1.1 The product
SV
The product is a multi functional measure tool with tape
measurer, spirit levels and different laser functions.
NO
1.2 Dedicated use
The product is used as a measurement tool for
example when you work with indoor decorations,
DA
outdoor constructions and installations.
1.3 Symbols
PL
Read the operating instructions carefully
and make sure that you understand the
DE
instructions before you use the product.
Save the instructions for future reference.
FI
Warning! Laser. Do not stare into the
beam.
FR
This product complies with applicable EU
directives and regulations.
NL
Recycle as electrical waste.
1.4 Product overview
Figure 1
1. Laser line button
2. Aperture for the laser point
3. Adjuster knob for the spirit level
4. Aperture for the horizontal and vertical laser line
5. Aluminium supporting surface
6. Battery lid
7. Spirit level for vertical alignment
8. Spirit level for horizontal alignment
9. Spirit level for 45° alignment
10. Lock switch for the tape measurer
11. Tape measure
12. Movable support piece
1
2 Safety
2.1 Safety definitions
Warning! If you do not obey these instructions,
there is a risk of death or injury.
Caution! If you do not obey these instructions,
there is a risk of damage to the product, other materials
or the adjacent area.
Note! Information that is necessary in a given situation.
2.2 Safety instructions for operation
● Read and obey the warning instructions before
operation.
● Do not use the product on airplanes and around
medical equipment, or in environment where there is
explosive gas, steam, or dust.
● Do not let children or persons who do not know the
product to use it.
● Do not point the laser beam at people or animals.
● Do not use the product if it is damaged.
● Do not make changes to the product.
● Use the product only for its specified function.
● Do not soak the product in water or any other liquids.
3 Operation
3.1 To use the self-lock tape
function
Caution! To avoid injury, retract the tape measure
at a slow speed.
● Push the lock switch button to lock the tape measure
in the applicable length. The tape will retract when
you push up the lock switch button.
3.2 Spirit levels
Refer to the illustrations in figure 2 to select the
applicable spirit level when you measure different angles.
3.3 Laser level
Figur 3
● Turn the adjuster knob to adjust the height of the
product when it stands on an uneven surface.
● Move the support piece back and forth to adjust to the
uneven surfaces.