Safety And Maintenance - Adviti Riolit Bedienungsanleitung

Installation
1. Switch off the power. To do so, disconnect the fuses.
2. Remove the side screws from the amp base so that the wiring cover can be removed (fig. 1).
3. Pull the wires through the hole in the base. Screw the lamp base to the desired location using the supplied screws (fig.2).
4. Connect the wires according to the diagram (fig.3).
5. Screw the lamp shadewith the sensor to its base(by screwing the sidescrews).
6. Switch on the power and test the operation of the lamp.
Test of device
- Turn the TIME knob to minimum (-). Turn the LUX knob to the maximum (sun).
When the power is switched on, the sensor will go into a calibration mode. After about 30 seconds, the lamp is fully ready for
operation. When the sensor detects movement, it will switch on the lamp, and then when it does not detect movement within
10±3 seconds, the lamp will switch off automatically.
- Turn the LUX knob counterclockwise
If the ambient light intensity is below 3LUX, the unit will operate and turn on the lighting. When no motion is detected in the
detection field, the lighting will turn off automatically
Note: If the sensor is tested in daylight, the "LUX" knob must be turned to the sun symbol position - otherwise the sensor will
notfunction properly!
Technical data
Nominal voltage: 230V-, 50Hz
LEDs type: SMD
Color temperature: 4000K
Light color (designation): neutral white
Power/luminous flux: 15VV / 11001m
Color rendering index Ra/CRI: 85
Working temperature: -20-+400C
Installation height: 1.8 -2.5m
Material: polycarbonate
Impact protection 1K (shock resistance): 'KIO
Ingress protection 'P: IP65
Dimensions: 170.7x159.2x80mm
Net weight: 0.38kg

Safety and maintenance

Any maintenance shall be carried out after the power source has been switched off.
Clean with dry and delicate cloths only.
Do not use chemical cleansers.
Do not cover the product.
Provide free air access.
Some problems and their solutions
1. The device does not work:
a. Please check the connection of the power supply and the receiver.
b. Please check the receiver.
c. Please check the sensor settings and ambient light settings.
2. Poor sensitivity:
a. Please check that there are no devices in front of the sensor that may interfere with the received signals.
b. Please check the ambient temperature.
c. Please that the object to be detected is within the detection field.
d. Please check that the installation height is in accordance with the recommendations.
e. Please check that the setting of the sensor position is correct.
3. The sensor cannot automatically
a. Please check if there are continuous motion signals in the detection area.
b. Please check that the time delay is not set to the longest value.
c. Please check that the power supply complies with the instructions.
to minimum (3). If the ambient light intensity exceeds 3LUX, the unit should not turn on.
PC + aluminium
switch off the load:
within 10 ±3 seconds.
PIR sensor technology
Detection angle: 1400
Detected object's speed: 0.6 - 1.5 m/s
Detection range: 9m
Adjustable daylight sensor: <3-20001ux
Adjustable time setting: min. 10sec_ 3sec;
max. 5min±
5
Imin