ECG TVP 7920 DVB-T Bedienungsanleitung Seite 77

Using a car adapter
If you are not using the device, unplug the adapter from the car lighter plug.
Antenna connection
• Attach the included antenna to the antenna terminal on the side of the device.
• Place the antenna on a fl at surface.
If the signal is weak, move the antenna or direct it towards a diff erent direction to achieve better
reception.
Embedded battery
The device is equipped with an embedded battery. Before using the device for the fi rst time, charge the
battery.
Notes:
• Use a designated charger.
• Do not throw into fi res or heat up.
• Do not use at high temperatures or near sources of heat.
• Do not open the cover.
• Servicing should be done by a qualifi ed service staff .
• To ensure maximum service life for your battery, charge at room temperature.
Headphones connection
Before connecting headphones, make sure the device volume is set to the minimum level. Continue by
gradually increasing the volume to an adequate level.
ATTENTION: Physicians warn against using headphones at high volumes for a longer period of time.
Listening at high volumes for longer periods of time can cause hearing damage. If you hear
a ringing noise in your ears or observe hearing loss, stop using the headphones and seek
medical attention.
Connecting a USB stick or memory card
The loading of data lasts a certain period of time. If you would like to unplug the device, turn it off fi rst and
then unplug.
AV signal output
To transfer the AV signal of the device (in AV mode) to an external display system, connect the output AV
connector with the AV input of the external device.
NOTE: 1. Follow the instructions in the manual of the connected device.
2. Before making the connection, switch off and unplug both devices.
Into DC IN jack
Into car lighter plug
EN
77