Operation - ClickTronic HC 461 Bedienungsanleitung

Note:
1. After you plug in the DC 5V power supply, the power will be turned
on. User is free to control the HC 461 in remote control, manual
select or auto switch.
2. The SELECT/AUTO button can also be used as an auto mode
control button. Press the button for 3 seconds to turn on or off the
auto switching function.
3. When the AUTO LED light is ON, the HDMI switcher can be operated
under remote control, manual select and auto detect.
User can switch input sources by these three functions.
4. When the AUTO LED light is OFF, the auto switching function will
be disabled. The HC 461 can be operated under remote control and
manual select.
5. If see the power indication LED light (Red) is flashing, the HDMI
switcher is detecting and connecting to the source. After the
source is detected and connected, the flashing will stop.
If the flashing continued, please check the power of your source is
on, or check the HDMI cable is working fine.
6. The HC 461 will memorize the latest input port. At your next use,
the HC 461 will detect and connect the latest input port first.

Operation

IR Remote operation mode
Use the IR remote to power on the HC 461, the power indication LED
on the front panel will light up. In the IR remote operation mode,
use number button to toggle between sources, or you can use the
forward and back button to select input sources.
Auto switching function operation mode
For your first connection, the HC 461 will detect and connect to the
first available source by following sequence.
Source 1
To switch to another source, you will only need to turn on the source
device you want to use. The HC 461 will automatically switch to the
source device that you turn on.
Auto switching mode control: user can set the auto switching func-
tion to OFF. Press the SELECT/AUTO key for 3 seconds to turn off the
auto switching function. Press another 3 seconds to turn it back on.
Manual operation mode
• Use the POWER key to turn on or off the power.
• The SELECT/AUTO key is used for manual switch. If you want to
change the input channel, you can only press the button once.
There will be a LED indication for what channel it is.
The procedure is a cyclic function.
Source 2 Source 3 Source 4 Source 5 Source 6
9