Quick Start Guide; Plug In & Power On - Transact Boha! Terminal 2 Kurzanleitung

QUICK START GUIDE

EN
1 . UNPACK
Your BOHA! Terminal 2 comes with the following items.
®
If any of the items are missing, contact TransAct
Sales Support.
1. BOHA! Terminal 2
®
2 . PLUG IN & POWER ON
1. Connect the included power
cord to the BOHA! Terminal 2
®
and a power source.
2. If your BOHA! Terminal 2
®
doesn't start automatically,
power up by pressing the
power button on the left side
of the device.
3 . LOAD LABELS
1. Open the BOHA! Terminal 2
®
by holding either side of the
lower section of the display
and lifting up.
1
®
2. Power Cord
2. Open the mechanism cover
by moving the blue cover
release lever to the left.
3. Place the rolls in the label
bucket and feed the labels
from the top through the
center of the label path.
4. Pinch the blue bucket width
adjustment lever on the side
of the paper bucket and gently
slide the sidewalls so they
close in on the paper roll.
Note: If the paper bucket width is set incorrectly there may
be issues with label feeding and tracking.
Correct
alignment
5. Close the print mechanism
cover and press down firmly.
The labels will automatically
align for printing.
Sidewall
Too loose Too tight
alignment alignment