RexXer RF-44-178 Original-Gebrauchsanweisung Seite 6

SPECIFIC SAFETY PROVISIONS
Check the tool, cord and plug before starting to
work. All possible faults must be repaired by
authorized person
Do not use the device for purposes other than
allowed for it.
Using your winch in a wrong way can result in
accidents or serious injuries.
Any damaged part should be fixed or replaced by a
certified repair shop.
Keep the product well maintained and clean to
make work smoother and safer.
Do not use the product when you are tired, have
drunk alcohol, used prescription or other drugs.
The user and/or the operator are liable for any
damages or injuries to people or goods.
When the product is not used, it should be locked in
a dry place.
Always lock the product and store it away from
children.
Prior to service, operation and maintenance works,
disconnect the device from power supply and dry it
off.
Do not pull the cable in order to plug it out from the
socket.
Do not pull the cord!
Connect only to electrical system equipped with
residual current circuit breaker that will cut the
power off when earth leakage current exceeds
30mA in less than 30ms.
Connect the device only to electrical installation
fitted with a protective circuit.
Power grid voltage must correspond to the one
specified on the tool's nameplate.
Do not direct the water jet from the pump at people,
animals, or electronic devices.
Use only pump accessories recommended by the
manufacturer.
*In spite of making all efforts possible, the
manufacturer cannot ensure 100% safety to those
who work with the tool. There is always a negligible
injury risk.
*The manufacturer is not liable for damages caused
by operation of a device which was subject to
construction changes or used improperly.
INCOMPLIANT USE
Do not use the tool:
in other ways than allowed by the manufacturer
It is prohibited to pump liquids other than water.
It is prohibited to dry run the pump. You should
always check if the pump is immersed in water
above the minimum level.
USE, COMPOSITION AND FUNCTIONS
The pump is a device powered by an electrical
engine of class I of electrical protection.
The pump is designed to pump water from artificial
and natural water reservoirs.
The device is designed to be used in households.
The device can be used indoors and outdoors.
The maximum temperature of pumped water is
35°C. Exceeding this temperature may cause
damage to the pump.
DESCRIPTION OF ILLUSTRATION PAGES
1. Power cable
2. Inlet holes
3. Hose connection
4. Water outlet
5. Elastic hose
6. Pump lifting rope
DESCRIPTION OF PICTOGRAPHS
Read the instruction.
Before any
maintenance works, disconnect the wire
from the powered tool's power source.
Keep children away from the device.
WORK
Prior to operating the pump, attach a water hose
with an inlet diameter suitable for the pump.
The pump should not be suspended, but always lie
on the bottom of the water tank.
Pay attention to the size of the shaft where you
wish to punt the pump in.
The distance between the shaft wall and the pump
should not be smaller than 10cm.
It is prohibited to use the pump if the power cord is
damaged.
Check if the pump is not at risk of dry running.
Start:
Attach the water cord to the pump.
Immerse the pump in water.
Set the hose outlet in such a way as to avoid
directing water flowing out under pressure on
people, animals, or electric devices.
Put the power plug in the power socket.
Stop:
Pull the power plug from the power socket.
Take the pump out of water.
Disconnect the water hose from the pump.
Dry the pump and the water hose.
MAINTENANCE
The pump does not require special maintenance
works, however, it is recommended to check the
pump from time to time (before use) for signs of
wear and tear to the power cord and to make sure
that pumping elements work smoothly.
If the pump does not start or a part of it is
mechanically broken, the pump must be sent to an
authorized service station for repair.
repair, adjustment or
6