Operations; Suggested Tank Feed; Installation Diagram - La Buvette AQUAMIX S Handbuch

Clicking Sound is Normal
Fluid flowing through the injector will automatically cause
the injector to "click" and inject a set amount of solution
into the fluid line. The higher the flow rate the more
frequent the "clicking". The injector is designed to inject
solution proportionally (at the same set ratio) regardless
of fluid flow.
Service Fluid Flow
Fluid flow and pressure must be within the established
specifications (see Specification on page 16) for your
model.
Change Feed (Injection) Rate
The feed rate on the injector is adjustable EVEN WHILE
OPERATING AND UNDER PRESSURE. To change feed
rate see (Fig. 1 and Fig. 2).
1. Remove Upper Interlock Pin (#65) (Fig. 1).
2. Rotate Ratio Adjuster Sleeve (#61) up or down to the
desired setting (Fig. 2). Use the top of the Ratio Adjuster
Sleeve to line up with the desired feed rate on the
setting (Fig. 2a).
3. Re-insert Upper Interlock Pin (#65). Clip must be
parallel with settings to be able to re-insert.
NOTE: Do not screw Ratio Adjuster Sleeve below lowest
setting line. Measure outlet fluid to assure desired feed
rate is being delivered.
Inlet Filter
(Recommended)
Fig. 4

Suggested Tank Feed

Installation Diagram

English: 18

Operations

50mm (2") Recommended
(B)
Pressure Safety
Device
(Recommended)
Inlet Valve
(Recommended)
Fig. 1
#65
Fig. 2a
Bypass Valve
(Recommended)
(A)
(C)
Outlet Valve
(Recommended)
Suction Tube
Covered Container
Solution Filter
50mm (2") Recommended
Fig. 2
A
A
#61
Fig. 3
Typical wall
mounting
Minimum Water Level
3 Meters/10 Feet