Quick Start; Important Information; Quick Start A7 - Adam A7 Bedienungsanleitung

2.1 Important Information for set up
After having unpacked your loudspeaker, please allow the system to accli-
mate to the temperature of the room. Please do not connect the speaker for
approximately an hour.
We recommend using high quality cables to guarantee optimal performance.
It is important to ensure the speakers stand firmly on a solid ground!
We recommend not to damage the package and to retain it. The original pack-
aging is the best guarantee for safe transportation (see 6., p. 12).
Please note that the loudspeakers will need a few days to achieve optimum
sonic performance.

Quick Start

2.2
a) Before connecting the loudspeakers to your audio components and the pow-
er source make sure that both the loudspeakers and your audio system is
switched off and set the level controls fully counterclockwise.
b)
Connect your sound sources or mixing console to the speaker. Verify which
type of connector to use. The RCA connectors are designed to receive
unbalanced, the XLR connector balanced signals. If both choices are
available, use balanced wiring. You will find the connector wiring printed on
the speaker's rear panel.
Check if the specified voltage matches the voltage of the power supply you
c)
use. If this is not the case do not connect the loudspeakers to a power source!
Please contact your local dealer or national distributor.
If the voltages match, connect the loudspeaker via the included power cables
to two AC sockets.
Switch on the main on/off switches on the front panel of the loudspeakers.
d)
e) Make sure that the line out level (volume) of your stereo is either at a low level
or all the way off. Then, switch on your audio system.
Turn on your source of music and adjust the volume carefully.
f)
6
2.
Quick Start