Quer KOM0834 Bedienungsanleitung Seite 14

sWitchiNg Off thE KEybOaRD
Press the power button
Hint: The USB receiver does not need to be
pulled out from the PC.
iR REMOtE OPERatiON
1. Press and hold (for about 4 seconds) the
SET button. The LED light on this device will
blink once and then flash in constant light.
2. Aim the device's infrared LED at your original
remote control's infrared LED. Note: the relative
distance should be not more than 7 cm.
3. Press the desired button on this device you
want to program; the LED light of this device
will blink two times, then flash with constant
light, signaling, it's in learning status.
EN
4. Press the chosen button on the original remote
control, this device's light will blink three
times, then flash with constant light, meaning
it has learned the button successfully.
5. Repeat the 2-4 steps for every button you
want this device to learn.
6. To exit learning mode, press the SET key on
this device, or withhold any operation for at
least 10 seconds.
to turn the keyboard off.
14