Herunterladen Inhalt Inhalt Diese Seite drucken

Setting The Clock; Setting The Timer - Learning Resources Magnetic Time Tracker Bedienungsanleitung

Magnetischer timer
Inhaltsverzeichnis
Verfügbare Sprachen

Verfügbare Sprachen

Setting the Clock

1. Use the POWER button to turn the Magnetic Time Tracker on and off.
2. Press the UP/DOWN buttons until the word Clock appears. Press ENTER.
3. Press the UP/DOWN buttons until the word Set appears. Press ENTER.
4. Use the UP/DOWN buttons to choose between 12/24-hour displays. Press ENTER.
5. Use the UP/DOWN buttons to set the current time, first by hour (ENTER), and then by
minutes (ENTER). Choose AM/PM (ENTER).

Setting the Timer

Set the timer for any amount of time from 1 minute to 24 hours. Use the timer with or without
a yellow "alert" light and sound. For example, to set the timer for 1 hour with an alert light 5
minutes prior to the end, set the total time for 60 minutes and the "alert" for 5 minutes.
1. Press the ENTER button. The word Timer will appear on the screen. Press ENTER.
2. The word Start will appear on the screen. Press the UP/DOWN buttons until Set appears on
the screen. Press ENTER.
3. The word Total will appear on the screen. Press ENTER. Then, use the UP/DOWN buttons to
set the amount of time for which the green light will be lit. First, set the hours (ENTER), then
minutes (ENTER), and finally seconds (ENTER).
4. The word Alert will appear on the screen. Press ENTER. Then, use the UP/DOWN buttons
to set the amount of time for which the yellow light will be lit. First, set the hours (ENTER),
then minutes (ENTER), and finally seconds (ENTER). Note: the yellow alert light cannot be
set for longer than the green light.
5. The word Sound will appear on the screen. Press ENTER. Then, use the UP/DOWN buttons
to select Yes or No (Y/N). Press ENTER.
6. To start the timer, press ENTER again. The green light will go on.
7. If selected, the yellow alert light will light up and an alarm will sound at the programmed
time. There will always be an audible countdown for the last 5 seconds.
8. The RED light will flash when time is up.
9. The timer will remain as programmed until you reset it, even if the power is turned off.
10. To restart the timer, press the POWER button. Then, select TIMER (ENTER) and START
(ENTER). The time will appear on the screen. Press ENTER again to start the timer.
VOLUME
To adjust the volume at any time, press the UP/DOWN buttons (UP to increase the volume, and
DOWN to lower the volume).
Use the Magnetic Time Tracker on most magnetic surfaces, hang it on a wall, or activate the flip-
out stand to set it on a desk or tabletop. Be sure to check that the unit is secure before use.
If the Magnetic Time Tracker malfunctions or is not operating properly, please use a paperclip or
pen tip to gently depress the recessed RESET switch on the back of the unit.
Battery Information
Installing or Replacing Batteries
WARNING! To avoid battery leakage, please follow these
instructions carefully. Failure to follow these instructions
can result in battery acid leakage that may cause burns,
personal injury, and property damage.
Requires: 4 x 1.5V AA batteries (not included) and 2 LR44
batteries (included), and a Phillips screwdriver
• Batteries should be installed or replaced by an adult.
• The Magnetic Time Tracker
®
requires (4) four AA batteries.
• The battery compartment is located on the base of the unit.
• To install batteries, first undo the screw with a Phillips
screwdriver and remove the battery-compartment door.
Install batteries as indicated inside the compartment.
• Replace compartment door and secure with screw.
AA
AA
AA
AA
Battery Care and Maintenance Tips
• Use (4) four AA batteries (not included) and 2 LR44
batteries (included).
• Be sure to insert batteries correctly (with adult supervision)
and always follow the toy and battery manufacturer's
instructions.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Do not mix new and used batteries.
• Insert battery with the correct polarity. Positive (+) and
negative (-) ends must be inserted in the correct directions
as indicated inside the battery compartment.
• Do not recharge non-rechargeable batteries.
• Only charge rechargeable batteries under adult
supervision.
• Remove rechargeable batteries from the unit before
charging.
Inhaltsverzeichnis
loading

Verwandte Produkte für Learning Resources Magnetic Time Tracker

Diese Anleitung auch für:

Ler 6968

Inhaltsverzeichnis