Otto DJ504784 Bedienungsanleitung
Quicklinks
Verwandte Anleitungen für Otto DJ504784
Inhaltszusammenfassung für Otto DJ504784
- Seite 1 DJ504784 Tools required Version:1.0 (not included)
- Seite 2 Warnung - Das Produkt muss gemäß den Schritten und Empfehlungen in der Anleitung installiert und verwendet werden. Der Verkäufer übernimmt keine Verantwortung für Verletzungen oder Schäden, die durch unsachgemäße Montage oder unsachgemäße Verwendung durch den Benutzer entstehen. - Kinder dürfen dieses Produkt nicht zusammenbauen. Während des Zusammenbaus sind alle Kleinteile außerhalb der Reichweite von Kindern zu halten, um ein Verschlucken oder Einatmen und damit verbundene Verletzungen zu vermeiden.
- Seite 3 Warning - The product must be installed and used according to the steps and recommendations in the instructions. The seller assumes no responsibility for any injury or damage caused by improper assembly or improper use by the user. - Children are not allowed to assemble this product. During assembly, all small parts should be kept out of the reach of children to avoid swallowing or inhaling and related injuries.
- Seite 4 avvertimento - Il prodotto deve essere installato e utilizzato secondo i passaggi e le raccomandazioni contenute nelle istruzioni. Il venditore non si assume alcuna responsabilità per eventuali lesioni o danni derivanti da un montaggio improprio o da un uso improprio da parte dell'utente.
- Seite 6 This product has two packages, box A and box B. Only the parts in the two packages can complete the entire table. Please be sure to start the installation after the two packages arrive...
- Seite 7 PACKING DETALS:TOTAL 2 BOXES BOX SKU DJ504784_A BOX SKU DJ504784_A PARTS PARTS...
- Seite 8 PACKING DETALS:TOTAL 2 BOXES BOX SKU DJ504784_B BOX SKU DJ504784_B PARTS PARTS...
- Seite 12 x61(+3) x61(+3) x38(+3) x39(+3) Ø6x35mm Ø15x10mm Ø6x30mm Ø4x40mm x92(+5) x16(+2) x16(+2) Ø3.5x12mm Ø3x16mm x4(+1) x50(+3) Ø5x40mm Ø4x16mm Ø4x12mm x22(+2) 30x10mm Ø20mm 300mm 300mm 300mm 300mm...
- Seite 13 Note: Before installation, you can place the cartons and foam used for product packaging on the floor, and then operate carefully on top of them to maximize the protection of the product from damage. 300mm 300mm Ø3.5x12mm Ex12 CRx4 Attention, first hole Attention, second hole...
- Seite 14 300mm 300mm Ø3.5x12mm CRx1 Attention, second hole Attention, first hole 180° Ex12 CLx4...
- Seite 15 Notice Note the third and fourth holes Notice Notice...
- Seite 16 Ø6x30mm 90° Notice...
- Seite 17 300mm 300mm Ø3.5x12mm Ex12 CLx4 Attention, first hole Attention, first hole Ex12 CRx4...
- Seite 18 Notice...
- Seite 19 Ø6x30mm 90° Notice...
- Seite 20 Notice Notice Small hole diameter...
- Seite 21 Ø15x10mm Ø6x30mm Cx14...
- Seite 22 Mx12...
- Seite 23 Ø6x30mm Notice Notice Notice Ax10 Notice Small hole diameter...
- Seite 24 Note: At least two people are required for this step. Ø6x30mm Need Two or More People To Complete Lx12...
- Seite 25 Note: At least two people are required for this step. Ø15x10mm Need Two or More People To Complete Cx10...
- Seite 26 Ø3.5x12mm...
- Seite 27 Ø6x30mm Lx12 Notice UP...
- Seite 28 Ax10...
- Seite 29 Note: At least two people are required for this step. Ø15x10mm Bx10 Need Two or More People To Complete...
- Seite 30 Ø3x16mm Ø4x12mm Mx10 Fx16 Gx16...
- Seite 31 Ø4x40mm Notice Notice 90° Ø6x35mm Ø15x10mm Notice Ø3.5x12mm 300mm 300mm...
- Seite 32 Notice Ø4x40mm Notice 90° Ø6x35mm Ø15x10mm Notice Ø3.5x12mm 300mm 300mm...
- Seite 33 Ø4x40mm Notice Notice 90° Ø6x35mm Ø15x10mm Notice Ø3.5x12mm 300mm 300mm...
- Seite 35 Please tear off the film on the outside of the mirror. mirror...
- Seite 36 Ø4x40mm WALL WALL WALL drilling hole Power supply...