VENDOMNIA RRGRG01 Original Bedienungsanleitung Seite 12

EN
2. When attaching [QB] to the base, make sure that [QB] is caught in between [HZ2]
and [DH]. After this step is done, the bottom end of [QB] is nested inside [DH].
3. We are using two [S3]+[S4] set and one [S1]+[S4] +[S2] set for this step. In
addition, you should use the upper screw hole on [DH].
4. You might need a helper to support the [QB] temporally after this step is done.
[S3]+[S4] x 7 [S1]+[S4]+[S2] x 2
[WZ1] x 1
LEFT
Notice
Position [QR] so it is nested inside [DR].
As stated on previous page, [QR] has a predesignated top and bottom. Do not mistake
its top for bottom.
12
[DR]
[S1]+[S4]+[S2]
[QR] x 1
[QR]
[S1]+[S4]+[S2]
RIGHT
If you have any further questions, please contact us:
2.3
[QR]
INSIDE
[DR]
contact@vendomnia.rs