OSRAM SMART+ WIFI RADIATOR THERMOSTAT Bedienungsanleitung Seite 4

SMART + WIFI RADIATOR THERMOSTAT
RAV
During installation, make sure that the pins inside the adapter (2) match
the notches (1) on the valve body. Ensure that the appropriate adapter for
the valve is clipped on correctly. The lifter extension (3) must be fitted to
the valve pin on RAV valves before installation.
Giacomini
During installation, make sure that the pins inside the adapter (2) match
the notches (1) on the valve body. Ensure that the appropriate adapter for
the valve is clipped on correctly.
1
Adjusting the Axle Tolerances
The valves from different
manufacturers may have
tolerance fluctuations that
make the radiator thermo-
s1on the valve. In this case,
the provided support ring
should be placed into the
flange before mounting the
radiator thermostat.
4
1
3
2
2
In some case, where the valve pin
has a different length greater than
14mm or radiator can not close the
valve to go down the temperature,
you will need to add a spacer inside
the base ring, the spacer comes
with two thickness, 0.5mm/1mm.
(refer as trouble shooting code F4).
RAVL
During installation, make sure that the pins inside the adapter (2) match
the notches (1) on the valve body. Ensure that the appropriate adapter for
the valve is clipped on correctly.
1
2
Caleffi
During installation, make sure that the pins inside the adapter (2) match
the notches (1) on the valve body. Ensure that the appropriate adapter for
the valve is clipped on correctly.
1
2
Finalizing the Hardware
Installation
• After "AdA" appear, the
radiator is ready to fix
with valve.
• Turn the thread ring to fix
with valve.
• After valve is well fixed, then
press „Confirm" button (F) to
enter adaptation step. In the
end, the main menu default
set temperature 17° appear.
Then the device is well
installed. If screen display
"F1/F2/F3/F4", refer to the
trouble shooting chapter.