Customer Service And Spare Parts; Installation; Location; Electrical Connection - JUNO JCG 94185 Gebrauchsanweisung

38 electrolux
CUSTOMER SERVICE
AND SPARE PARTS
If the appliance is not functioning
properly, check that:
• the plug is firmly in the wall socket
and the mains power switch is on;
• there is an electricity supply (find
out by plugging in another
appliance);
• the thermostat knob is in the
correct position.
• If there are water drops on the
bottom of the cabinet, check that
the defrost water drain opening is
not obstructed (see "Defrosting"
section).
• If your appliance is still not working
properly after making the above
checks, contact the nearest service
centre.
To obtain fast service, it is essential
that when you apply for it you specify
the model and serial number of your
appliance which can be found on the
guarantee certificate or on the rating
plate located inside the appliance, on
the bottom left-hand side.

INSTALLATION

Location

The appliance should be installed
well away from sources of heat such as
radiators, boilers, direct sunlight etc.

Electrical connection

Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must
be used.
The appliance must be earthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to
a separate earth in compliance with
current regulations, consulting a
specialist technician.
The Manufacturer declines all
responsibility if the above safety
precautions are not observed.
This appliance complies with
the following E.E.C. Directives:
• 87/308 EEC of 2/6/87 relative to
radio interference suppression.
• 73/23 EEC of 19.2.73 (Low Voltage
Directive) and subsequent
modifications;
• 89/336 EEC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent
modifications.
ATTENTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.