Yealink RT30 Bedienungsanleitung Seite 7

Before the cascade registration, you should first register the two repeaters
to the base station. For cascade registration, we recommend that you put
the two cascaded repeaters closer to each other. One repeater attempts
to register to the other repeater (destination repeater). If the destination
repeater de-registers, the repeater does as well. Conversely, it does not.
The repeater supports automatic or manual cascade registration.
Auto Cascade Registration
1. Long press the program key on one repeater for about 3 seconds.
The repeater starts searching for the other repeater, POWER LED turns
orange and DECT LED flashes green.
Wait until POWER LED turns green and DECT LED turns green/orange,
auto cascade registration is successful.
Manual Cascade Registration
1. On one repeater:
a. Confirm the ID: Press the program key. The number of times that
RELAY LED flashes indicates the ID. Press the program key again to
return to the operation mode.
2. On the other repeater:
a. Long press the program key for about 3 seconds.
b. Press the program key as soon as POWER LED turns orange and
DECT LED flashes green, to enter the repeater's ID to be cascaded.
Pressing once indicates that the ID is 1.
POWER LED turns orange and DECT LED turns green.
c. Press the program key for about 3 seconds to confirm the ID.
The repeater starts searching for the repeater to be cascaded, POWER
LED turns green and DECT LED flashes orange.
Wait until POWER LED turns green and DECT LED turns green/orange,
manual cascade registration is successful.
ID Modification
After registering to the base station, every repeater has its own ID, it uses ID
to distinguish with each other. If the IDs of two repeaters conflict, you need
to modify the ID manually.
1. Press the program key to confirm the ID.
2. Long press the program key for about 7 seconds to enter the ID
modification mode.
Both POWER LED and DECT LED turns red.
3. Press the program key to enter the new ID. Pressing once indicates that
the ID is 1.
The number of times that the RELAY LED flashes indicates the entered
ID.
4. Long press the program key for about 3 seconds to confirm the ID.
DECT Repeater RT30 User Guide
E
N
G
L
I
S
H
5