Herunterladen Inhalt Inhalt Diese Seite drucken

Rear Panel; Handheld Microphone; Receiver; Beltpack Transmitter - Advanced Native Technologies Start 16 Bedienungsanleitung

Uhf-funksysteme
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Series

REAR PANEL

1
2
1 "DC 12-18V" POWER SOCKET
Connect to this socket only the supplied power supply.
2 UNBAL
Unbalanced audio output with 6,35mm (1/4") jack. Connect this output into an
unbalanced input of your mixer.
3 AF OUTPUT
Balanced audio output with XLR-M socket. Connect this output into a balanced input
of your mixer.
2.2 | HANDHELD WIRELESS MICROPHONE - START 16M
1
2
3
1 GRILLE
It protects the microphone capsule from impacts and/or accidental falls and it
reduces the noise of the plosive.
START 16 Series
6
User manual |
3
4
5
2 POWER ON AND BATTERY STATUS INDICATOR
GREEN: Transmitter activated (ON), charged batteries.
RED: Immediately replace the batteries.
WARNING: battery life is about 8 hours, but it may vary according to the
usage conditions.
3 ON/OFF
Press this button for 3" to turn on or off the wireless handheld microphone.
4 BATTERIES COMPARTMENT
To access the battery compartment unscrew the lid counterclockwise, and
screw the lid clockwise to close it. Remove the batteries from the receiver
when not in use for extended periods.
5 IR WINDOW
It allows the synchronization of the channel (frequency) with the receiver.
After pressing the ASC button, place the bottom of the wireless microphone
close to the IR window of START 16R receiver and wait for the selected
channel to stop flashing on the handheld display. After the synchronization,
the receiver's display is lit steadily on the selected channel (frequency).
2.3 | BELTPACK TRANSMITTER - START 16B
1
3
2
7
4
5
6
1 ANTENNA
It allows the transmission of the
signal.
2 ON/OFF
Press this button for 3" to turn ON
or OFF the beltpack transmitter.
3 IR WINDOW
It allows the synchronization of
the channel (frequency) with the

receiver.

After pressing the ASC button,
place the beltpack transmitter
close to the IR window of START
16R receiver and wait for the
selected channel to stop flashing
on the handset display. After
START 16 Series
| User manual
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis