VEVOR C110 Bedienungsanleitung Seite 9

and hold on for 3 seconds, release the button after hearing l short chirp, the
system save the set data and quit the mode.
7. Tyre pressure code matching Long press the (+) button for 3 seconds and
release it after hearing a long "Bi" to enter the tyre pressure code matching mode,
the left front wheel icon and "_." fash press the " SET " button to select the tyre to
be matched, and the corresponding tyre after selection "_." will flashing, at this
time, inflate the corresponding tyre (The external sensor is directly screwed to the
valve), after receiving the signal "_." changes to the pressure value to indicate that
the matching is successful, then short press the (+) button to jump to the next tyre.
Follow the previous step to match other tyres, After matching, press and hold the
(+) button for 3 seconds,save and exit after a "Bi" (Entering the tyre matching
mode without any action, the matching mode will automatically exit after 3 minutes)
(Note: The sensor and receiver have been matched before leaving the factory, and
the sensor or receiver needs to be re-matched to change the sensor or receiver.)
INTERNAL SENSOR INSTALLATION