SUNLU FilaDryer S4 Bedienungsanleitung

SIJnLU
FilaDryer S4
3D Printing-Mate
User Guide
EN
RoHS
Zhuhai Sunlu Industrial co., Ltd.
Official website: www.3dsunlu.com
Brand cooperation: branding@sunlu.com
Business cooperation: sales@sunlu.com
After-sales service: support@sunlu.com
Address:No. 38,YongtianRoad, SanxiScienceand Innovation Town,
Xiangzhou District, Zhuhai City,GuangdongProvince,China
Note: Please read this document before using the
filament
1. Do not place this product within the reach of children.
2. Pay attenton to electrical safety during operation. Do not use this
product near water, such as bathrooms,
where water is easilytaken.
3. Pleaseuse the original power cord or a power cord that meets safety
certification
4. When not using this product, please turn off the power to avoid
sudden fire.
5. When drying filaments, do not place the product on tempera-
ture-sensitive objects,
6, When drying filaments, please do not touch the heater or fan inside
the box to avoid burns. When drying filaments, the upper cover of the
drying box should be covered to avoid heat loss
7. In order to ensure the drying effect, do not open the dryer box at will
during the operation.
8. If the product fails, please turn off the power and disconnect the
power cord from the power outlet, then contact the after-sales support
team.
Product performance
Project
Product Size
Internal Size
Working temperature/humidity
Temperature
Power Input Specifications
Standby power
Maximum
Filament diameter
Product function
ICN
MADE IN CHINA
EN
dryer
bathtubs, washbasins,
requirements
parameters
Parameters
460(
4kg
15 c -35 c
35 c-70 c
settlng range
AC Ilov 60Hz 330W
0.25W
working current 3,1A
1.75mm/2.gsmm/3.Omrn
diagram:
Filament Outlet
Control Panel
Top Cover
Filament Outlet
Power Input
Steps:
1. Install the Teflon tube (insert the Teflon tube into the filament
according to the picture).
etc.
2. Open the top cover and put the filament into the dryer box.
Toggle the switch backwards first, then pull it up
3. Thread the filament through the filament output of the filament
dryer and the Teflon tube.
Method 1
4. Connect the power supply and pressthe switch.
outlet
Method 2