Device Basic Start Up - urmet domus HOME NVR H.264 Kurzanleitung

3

DEVICE BASIC START UP

Use a monitor with VGA or HDMI input for device start-up. Carefully follow the instructions below.
Otherwise, the device can also be configured without monitor, using a networked PC station, following the instructions in
Quick guide DS1093-155_HOME NVR_IE QUICK GUIDE_it_en_sp, available in the CD provided with the NVR.
Before installing the NVR, check that IP cameras are properly working and connected (via cable or WiFi) to the
1.
same network as the NVR. For Urmet Colud cameras network connection and installation, see the instructions
provided with cameras.
Before NVR power on, perform the following connections:
2.
Connect the mouse to one of the two USB ports
o
Connect the monitor to HDMI or VGA output on the rear panel
o
Connect a network cable end to the network port in the NVR rear panel and connect the other end to
o
the switch or modem/router port.
Power on the device by inserting the power supply connector into the NVR power supply plug
3.
If the NVR is connected to a LAN where a DHCP service is active, a valid IP address will automatically be assigned
4.
to the NVR. To check the IP address assigned to the NVR by the LAN network, perform as follows:
Access the NVR OSD menu by pressing the right mouse button and enter the administrator password
o
(default: 00000000)
In the page [Menu
o
for assignment and automatic display of network parameters.
If the LAN network doesn't support the DHCP service, in the NVR page [Menu
o
from DHCP mode to "Static" mode, then manually enter the suitable network parameters: IP address,
Mask, Gateway, DNS.
DS1093-154
Network] display the NVR current network parameters: wait about ten seconds
23
Network] change