Karaca INOX 2303 Bedienungsanleitung Und Garantie Seite 20

After finishing the setting, press the button " " again, the LED " " will light
on and the product will start running. When the display indicates the set
temperature, the kettle will stop heating. At this time, the LED " " will light
off and the buzzer will beep for three times. The LED " " will light on and the
kettle will enter the Keep Warm state. When the water temperature is lower
than the set temperature by 3°C (37.4°F), the product starts heating until the
water temperature reaches the set temperature. The circulation operates
until the kettle enters the standby state (repeated heating until there is no
beep). The display will light off if no any operation is started within 2 hours.
After the setting of Keep Warm temperature, when the current water
temperature is greater than or equal to the set temperature, the buzzer will
beep for three times as an indication of up to or exceeding the Keep Warm
temperature. At this time, the kettle enters the Keep Warm state directly. To
exit from this state, press the button " " or " " again, and the product will
enter the standby state immediately.
Notes: Press " " when the temperature is set to 100°C (212°F)", when the
water temperature reaches 100°C (212°F), the product will not enter the heat
preservation state, but immediately enter the standby state.
At this time, the kettle stops heating. When the water temperature is lower
than the set temperature by 3°C (37.4°F), the product starts heating until the
water temperature reaches the set temperature. The circulation operates
until the kettle enters the Standby state (repeated heating until there is no
beep). The display will light off if no any operation is started within 2 hours.
After the setting of Keep Warm temperature, when the current water
temperature is greater than or equal to the set temperature, the buzzer
beeps three times as an indication of up to or exceeding the Keep Warm
temperature. At this time, the kettle enters the Keep Warm state directly. To
exit from this state, press the button " " or " " again, the product will enter
the standby state immediately.