Venjakob TAGENA Aufbauanleitung Seite 3

55071-01
Assembly instructions "TAGENA":
Cabinet with feet
The fixture materials provided with this product (dowels and screws) are only suitable for fixing parts to concrete and/or solid masonry. Please observe the
maximum load that the wall-mounted elements can carry. Ideally, the suitability of the wall should be enquired about when the order is made and must be
checked by specialist staff before the cabinet is assembled at the latest. If the condition of the wall is not suitable (e.g. if it is a lightweight partition wall),
then another type of fixture suitable for the load that is to be carried should be used. Check the electrical input of any connection or device technology.
Free-hanging light fixtures require cable duct solutions that are either on or under plaster.
These assembly instructions are valid for the following order no.:
Lowboard: 8200, 8201, 8202, 8203, 8204, 8205, 8206, 8207, 8208, 8209, 8210, 8211 | Sideboard: 8221, 8223, 8225, 8227, 8229, 8235, 8237, 8239, 8241, 8243,
8245, 8247, 8249 | Highboard: 8251, 8252, 8253, 8254, 8255, 8256, 8260, 8261, 8262, 8263, 8264, 8265 | Cabinet: 8268, 8269
Maximum load-bearing capacity: wood shelf: 15kg | drawer: 5kg
Please read and follow all assembly instructions carefully.
For reasons of weight, it is advisable to dismantle front parts such as doors
and drawers when transporting the furniture.
Transportation and assembly should always be carried out by two people!
Variant A
1. Remove the transport protection & the transport lock underneath
the furniture.
Variant A: Screw adjustable feet (Part No.05591) into the lower
corner nodes of the frame.
Variant B: Insert furniture glides (Part No.50611) into the base
bottom. Check that all the accessories are firmly seated, retighten if
necessary and place the cabinet onto a stable and level floor.
3. Additional item lightning → See assembly instruction "Wiring diagramm"
4. Mount the reinforcement profile under the furniture using the
countersunk screw M4x20mm (Part No.51245). Use an Allen key
SW5 to do so.
Alfons Venjakob GmbH Co. KG
Friedrichsdorfer Str. 220
33335 Gütersloh, Germany
Variant B
2. Furniture consists of several packages → see additional
assembly instructions "Body and frame assembly".
5. For furniture width from 124cm up to 243cm a additional
stabilization by means of support brackets (Part No.50451) on the
wall is required.
For this purpose, determine the position of the type on the wall,
position the bracket under the furniture perpendicular to the centre
panels / body connection and mark the drilling position on the
masonry. Then drill the ø8mm hole in the masonry. Anchor the
dowels 8x51mm (Part No.50802). Fasten the support bracket on the
wall using 2 screws 5x50mm (Part No.00055).
E-Mail: venjako@venjakob-moebel.de
Tel.: +49 52 09 5 92-0
Erstellt am: 14.05.2025
3 / 4