HOMCOM 800-258V90 Bedienungsanleitung Seite 8

TROUBLE SHOOTING
TROUBLE
Power indicator not on
Power off automatically
LED shows E0
LED shows E2
LED shows E3
LED shows E4
LED shows E5
LED shows E6
Note: If the faults can not be resolved, please do not disassemble the appliance by yourself, but
return it to the service center for repairing. If you disassemble the appliance by yourself, we have
the right to make the warranty invalid. Dangers or other safety accidents caused by this will also be
charged to the user.
POTENTIAL CAUSES
Power cord is not connected
well
1. Spare parts over heat
2. No operation in two hours
1. No pot
Pot too small
2.
Temperature sensor
circuit or short circuit
High voltage protection
Too low voltage protection
High temperature protection,
more than 180℃
IGBT overheat, more than
100℃
RESOLUTION
Please ensure the plug inserted
into the socket
Please restart
otherwise, return it to the
service center for checking and
repairing
Put the suitable pot on the
surface of the cooker. It will
return to the state of power on
if without any operation for 30
seconds.
open Please return the cooker to the
service center for checking and
repairing
Please ensure 150V ＜ voltage
＜270V.
Please ensure 150V ＜ voltage
＜270V.
Start again
temperature cool down
Please check if the air intake
and outlet is jammed. If not,
please return the cooker to the
service center for checking and
repairing
the cooker,
after the