Check Content Of Delivery; Assembling The Armchair; Using The Armchair; Set The Lying Position - Duo Collection Ronda 20401670 Originalbetriebsanleitung

Check content of delivery

NOTE!
Damage risk!
If you open the packing without
due care with a sharp knife or oth-
er pointed tool. Then the armchair
could easily be damaged.
• Therefore please take great care
when opening.
1. Remove the armchair from the packaging.
2. Check for any visible signs of damage. If there
are any, please do not use the armchair. Contact
your retailer.
3. Check that the contents of the delivery are
complete.

Assembling the armchair

WARNING!
Risk of injury!
Improper use of the armchair can
result in serious injury.
• To avoid any injuries caused by
pinching, take care when moving.
4
1. Place the seat of the armchair on a flat
surface.
2. Take the rest 1 and lift it over the seat.
3. Place the guide rail
the guide pin 2 on the seat.
4. Press down firmly from above, until the back
rest clicks into place and cannot be moved.
5
5. The cover comes with a hook and loop
fastening. Attach the cover so that it fits tightly
over the seat.
6. Put the plug into the mains socket.
6
of the rest carefully on

Using the armchair

WARNING!
Risk of injury!
Improper use of the armchair can
result in serious injury.
• If the event of any fault with the
electrics, please contact a special-
ist. Damaged electrical devices
should not be used.

Set the lying position

In this mode, you can adjust the back rest and
the foot rest on the armchair. This means you
can reach a lying position.
1. Sit in the armchair.
2. Press the button for lying position
remote control
7
The foot rest moves up.
3. If you do not want a full lying position, you can
select an intermediate position. To do this, press
the lying position button until you have reached
the position you want.
4. If you release the button, the back rest and
foot rest stop moving.
5. If you would like to go back to the upright
position, press the button for standing assis-
tance .
8

Set the standing assistance

This mode helps you when standing up from
the armchair. This makes the chair go up slightly
and tip forwards a little.
1. Sit in the armchair.
2. Press the button for standing assistance
on your remote control. The armchair straight-
ens up.
3. Stand up.
The USB port of the remote control has
10
a maximum output power of DC 5V 2A. Do
not connect any devices with a higher power
consumption to the USB-A port or the USB-C
adapter. Please ensure that connected USB
cables and end devices do not get into the
mechanism.
48
on your
9
. The back rest moves back.
8