Rec/Pb System Adjustments - Rotel Rpm-10 Technische Anleitung

— REC/PB
instruments: Signal Generator,
Conditions: Dolby NR
Adjustment
REC/PB Output
Level
Distortion Check
Frequency
Response Check
System
H.D. Analyzer and Blank Tape
OFF REC Level. . Maximum
Conditions
S.G. (400Hz OdB) LINE IN
TP5 (6) LINE OUT . TP13 (12
Release Pause Button
and playback it again.
S.G. (400Hz OdB) LINE
TP5 (6) LINE OUT . TP13 (12
LINE
H.D. Analyzer
Release Pause Button
and playback it again,
If the distortion factor exceeds the above, recheck Bias Current Adjustment.
METAL Tape insert
Cr02 Tape insert it
NORMAL Tape insert
Adjustments
PLAY, REC, PAUSE.
Adjust
VR703 (L.ch)
VR704 (R ch)
IN
Check that distrotion
a. METAL Tape.
OUT b. SPECIAL
c. NORMAL
VR90 1 (L-ch)
it
VR902 (mh)
it
— 20 —
ON
Adjust for
Recording and Playback
difference must be within
is within following
. . under
Tape.
under
Tape
under
40Hz—125Hz . . 5dB
10KHz--15KHz . 5dB
40Hz -125Hz... 5dB
10KHz-14KHz . . 5dB
level
ldB
range.
2%
2%
125Hz-10KHz, . .3dB
125Hz-10KHz .
. 3dB