urmet GROTHE RL300FV Bedienungsanleitung Seite 4

5. Lamp head:
A.The lamp head can be rotated by 180 degrees as shown in the diagram below, and
also turned left and right or to face up and down.
Installation:
Warning: This equipment must be installed only by a qualified electrician. Installation must follow local building
codes as well as the instruction contained this manual. Turn off al power at circuit breaker or fuse box, to make sure
power is off before installation. If you have any doubts about the installation procedure, please ask a qualified
mechanican.
I .The unit is to be mounted vertically on a wall (Figure F,G),protected from weather.
2. Open the front cover of sensor (Figure F),unscrew the inner plastic cover, fix the
sensor through the breakout (Figure G), Ensure the sensor is screwed securely to the
wall without movement.
3. DO NOT place the sensor light close to any surface, asthe light can get very hot.
Keep the light at least 80mm away from walls to ensure sufficient air gap.
4. Point the sensor towards the area to be covered.
WARNING: HOT SURFACE, DO NOT TOUCH.
Screw *2
Figure. G
Figure. E
o
o
0 0
rubber seal
Figure. F
Installation hints:
To ensure the best performance from your RL300Series,refer to the following figures to help choose the
ideal location.
• MOUNT ON STABLE SURFACE
. DON'T EXPOSE TO RAIN OR ICICLES
MORE SENSITIVE TO MOVEMENT
ACROSS THE PATH
t
• KEEP AWAY FROM AIR VENTS
DON' MOUNT ABOVE LAMPS
. AIM SENSOR DOWN TO REDUCE RANGE
• AVOID REFLECTED LIGHT FROM
BRIGHT SURFACES
POSITION SENSOR EXACTLY LEVEL
FROM SIDE TO SIDE
• AIM SENSOR DOWN TOWARDS GROUND