Xceed EX28RHP Originalbetriebsanleitung Seite 11

OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully.
INTENDED USE
The machine is intended for hammer drilling
in concrete, brick and stone as well as
for light chiseling work. It is also suitable
for drilling without impact in wood, metal,
ceramic and plastic.
1. ADJUSTING THE AUXILIARY
HANDLE (See Fig. 1)
For your personal safety we recommend
using the auxiliary handle at all times.
To adjust the handle, loosen the bottom of
the handle anti-clockwise and rotate the
handle around the handle collar until the
handle is in the desired position. Tighten fully.
2. FITTING BITS OR CHUCK (See Fig. 2)
Clean the bit shank and apply grease
before installing the bit. Hold the rotary grip,
pull back the lock sleeve and insert the bits
or chuck into the bit holder. Turn the bit and
push it in until a resistance is felt, the shaft
drops completely into bit holder. Once you
are satisfied it has seated, release the black
lock sleeve. This should lock the bits or
chuck into position.
After installing always make sure that the
tool is securely held in bit holder by trying
to pull it out.
If the bits or chuck is not located well,
repeat the operation again.
3. REMOVE SDS TOOL
To remove the tool, pull back the locking
sleeve, hold and pull the tool out.
4. OPERATING THE SAFETY ON/OFF
SWITCH
Press the on/off switch in for operation,
release the switch to stop. (See Fig. 3)
5. HAMMER DRILL FUNCTION
1. Adjust the hammer and chisel action
selector to position "
rotation of the chuck. (See Fig.4)
It could cause a hazard if the selector
switch is not firmly locked.
NOTE: Press the selector switch lock
button before adjusting the dial selector
everytime.
2. Adjust the hammer and drilling action
selector to position "
hammer action. (See Fig.5)
3. You are now set up for hammer drilling
into masonry.
6. DRILLING FUNCTION
1. Adjust the hammer and chisel action
selector to position "
rotation of the chuck. (See Fig.6-1)
It could cause a hazard if the selector
switch is not firmly locked.
NOTE: Press the selector switch lock
button before adjusting the dial selector
everytime.
2. Adjust the hammer and drilling action
selector to position " " to stop the
hammer action. (See Fig.6-2)
3. You are now set up for drilling function.
7. CHISEL FUNCTION
1. Adjust the hammer and chisel action
selector to position " " to stop rotation
of the chuck. (See Fig.7-1)
It could cause a hazard if the selector
switch is not firmly locked.
NOTE: Press the selector switch lock
button before adjusting the dial selector
everytime.
2. Adjust the hammer and drilling action
selector to position "
hammer action. (See Fig.7-2)
3. You are now set up for chisel work using
hammer action.
8. USING THE DEPTH GAUGE
1. Rotate the handle anti-clockwise, insert
depth gauge into the handle(See Fig.8).
" to provide
" to provide the
" to provide
" to provide the
EN-11